Changing The Bios Settings; Changing The Boot Sequence For The Current Boot - Dell Adamo XPS Service Manual

Setup instructions (70 pages)

Table of Contents

1. Enter the system setup program.

2. Press the left- and right-arrow keys to highlight the Boot tab.

3. Press the up- and down-arrow keys to highlight the Boot Device Property, and then press <Enter>.

4. Press the up- and down-arrow keys to select the boot device you want to change, and then press <Shift + 1> to enable or disable a device, or <+> to

move the device up in the list, or <-> to move the device down in the list.

5. Press <F10> and then press <Enter> to exit the system setup program and resume the boot process.

Boot sequence changes take effect as soon as you save the changes and exit the system setup program.

Changing the Boot Sequence for the Current Boot

You can use this setting to boot your system from your preferred device only for the current boot. The system reverts to the original boot sequence the next

time you restart your computer.

1. Shut down the computer through the Start menu.

2. Turn on the computer. When the DELL logo appears, press <F12> immediately.

NOTE:

If you wait too long and the Windows logo appears, continue to wait until you see the Windows desktop, then shut down your computer

and try again.

3. When the boot device list appears, highlight the device from which you want to boot and press <Enter>.

The computer boots to the selected device.

Changing the Boot Sequence to a USB Device

1. Connect the USB device to a USB port.

2. Turn on (or restart) your computer.

3. When F2 = Setup, F12 = Boot Menu appears in the bottom corner of the screen, press <F12>.