INSTRUCTION MANUAL BEDIENUNGSANLEITUNG MANUAL INSTRCUTIUNI РЪКОВОДСТВО ЗА ЕКСПЛОАТАЦИЯ UPUTE ZA UPORABU UPUTSTVO ZA UPOTREBU PRIRUČNIK FLAT DIGITAL TV DIGITALER FLACHBILDFERNSEHER TELEVIZOR DIGITAL CU ECRAN PLAT LCD / LED ТЕЛЕВИЗОР FLAT DIGITALNI TV PRIJAMNIK FLAT DIGITALNI TV ZARAVAN DIGITALNI TELEVISOR...
Page 2
Quick Start Guide Insert the batteries into the Remote Control Insert two AAA/R3 or equivalent type batteries inside. Observe the correct polarity (+/-) when inserting batteries and replace the battery cover. REAR SIDE OF THE TV Satellite Connect the antenna to your TV * The back connection options may differ depending on the model Aerial Cable...
Page 3
HDMI input PLEASE ENSURE BOTH UNITS ARE SWITCHED OFF BEFORE CONNECTING. Use a HDMI to HDMI cable to connect the two units together. To select the HDMI input, press the Source button on the remote control. Each time it is To HDMI connection pressed the on-screen menu confirms your selection.
Page 4
Connect your TV to the Internet Connectivity feature allows you to connect your TV to the home network wired or wirelessly. You can use this networking system to connect to the Portal or to access photo, video and audio files that are stored on a Media server connected to the network and play/display them on the TV.
Contents Safety Information ..........2 Markings on the Product......... 3 Preparation ............. 3 Features ..............4 Specification ............5 Remote Control RC 4848 (depending on the model)..............TV and Operating Buttons (depending on the model)..............8 Power Connection ..........8 Antenna Connection (depending on the model) ....
• Do not expose the TV to direct sunlight, Safety Information open flames or place it near intense heat sources such as electric heaters. CAUTION • Listening in excessive volumes from earphones and RISK OF ELECTRIC SHOCK headphones may cause hearing loss. DO NOT OPEN •...
Markings on the Product WARNING The following symbols are used on the product as a marker for restrictions and precautions and safety Never place a television set in an unstable instructions. Each explanation shall be considered location. A television set may fall, causing where the product bears related marking only.
Notification Features • Remote controlled colour TV TRADEMARK ACKNOWLEDGMENT • Fully integrated digital terrestrial/cable/satellite TV Manufactured under license from Dolby Laboratories. (DVB-T-T2/C/S-S2) Dolby and the double-D symbol are trademarks of Dolby Laboratories. • Fransat Installation Option • HDMI inputs to connect other devices with HDMI sockets •...
Waste Disposal: Specification Packaging and packaging aids are recyclable and PAL BG/I/DK/LL’ should principally be recycled. Packaging materials, TV Broadcasting SECAM BG/DK such as foil bag, must be kept away from children. Batteries, including those which are heavy metal-free, VHF (BAND I/III) - UHF Receiving Channels should not be disposed of with household waste.
Remote Control RC 4848 (depending on the model) 1. Standby: Switches On / Off the TV 2. TV: Displays channel list / Switches among broadcast types / Switches to TV Source 3. Volume +/- 4. Menu: Displays TV menu 5. OK: Confirms user selections, holds the page (in TXT mode), views channel list (DTV mode) 6.
Page 11
Connections (depending on the model) Connector Type Cables Device NOTE: When connecting a device via the YPbPr or Side Scart Connection AV input, you must use the (back) connection cables to enable connection. For Side AV input you should use the supplied cable. See Connection (back) the illustrations on the left side.
Power Connection TV and Operating Buttons (depending on the model) After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the mains. Power Cable Connection: IMPORTANT: The TV set is designed to operate on Standby/On 220-240V AC, 50 Hz socket.
Note: When the TV is switched into standby mode, Environmental Information standby LED can blink to indicate that features such as This television is designed to be environment friendly. Standby Search, Over Air Download or Timer is active. To reduce energy consumption, you can follow these The LED can also blink when you switch on the TV from steps: standby mode.
Analogue: If Analogue broadcast search option is file will be stored in the TV. If there are any installed turned on, the TV will search for analogue broadcasts terrestrial, cable and/or analog services, they will be after other initial settings are completed. kept and only satellite services will be removed.
record the next event on the EPG. In this case, an If the writing speed of the connected USB disk is not OSD will be displayed, indicating the programmed sufficient, the recording may fail and the timeshifting events for recording. Press Stop button to cancel feature may not be available.
try restarting the recording. If you still get the same menu as Amplifier. The TV speakers will be muted error, it is possible that your USB disk does not meet and the sound of the watched source will be provided the speed requirements.
3 AM search and upgrade mode feature. If you cannot record, try switching off the TV and then re-inserting the USB device. Your TV will search for new upgrades at 3:00 o’clock if USB is too slow Automatic scanning option in the Upgrade Options menu is Enabled and if the TV is connected to an If a “USB disk writing speed too slow to record”...
Page 19
For models with built-in WLAN system: Wait until the IP the address is shown on the screen. This means that the connection is now established. Broadband To disconnect from a network, you should highlight connection Network Type, press Left or Right button and set as Disabled.
Page 20
Open the sharing application on your mobile device. Audio Video Sharing These applications are named differently for each Audio Video Sharing support is only available in the brand, please refer to the instruction manual of your Media Browser Folder mode. To enable folder mode, mobile device for detailed information.
Page 21
Portal service content and the interface may be Connecting Other Wireless Devices (depending changed at any time without prior notice. on the model) Your TV supports another short range wireless Open Browser (depending on the model) connection technology too. A pairing is required before Open Browser function is one of the applications on using these kind of wireless devices with the TV set.
Page 22
AV and HDMI Signal Compatibility PC Input Typical Display Modes The following table is an illustration of some of the Source Supported Signals Available typical video display modes. Your TV may not support all resolutions. SECAM Index Resolution Frequency NTSC4.43 640x350 85Hz (SCART)
Supported DVI Resolutions When connecting devices to your TV’s connectors by using DVI converter cable(DVI to HDMI cable - not supplied), you can refer to the following resolution information. 56Hz 60Hz 66Hz 70Hz 72Hz 75Hz 640x400 þ 640x480 þ þ þ...
The content and services available through the SmarTVue portal are provided by third-party providers and may be altered, suspended or discontinued at any time without notice. Hitachi is not responsible for any of the content or services and does not warrant the availability of or access to such content or services.