Configuring Ethernet Interfaces; Information About Ethernet Interfaces; About The Interface Command - Cisco Nexus 5000 Series Configuration Manual
Nx-os layer 2 switching configuration guide, release 5.0(3)n1(1)
Hide thumbs
Also See for Nexus 5000 Series:
- Cli configuration manual (660 pages) ,
- Configuration manual (334 pages) ,
- Command reference manual (196 pages)
Table of Contents
Advertisement
Configuring Ethernet Interfaces
This section describes the configuration of the Ethernet interfaces on a Cisco Nexus 5000 Series switch. It
contains the following sections:
•
•
•
•
Information About Ethernet Interfaces
The Ethernet ports can operate as standard Ethernet interfaces connected to servers or to a LAN.
The Ethernet interfaces also support Fibre Channel over Ethernet (FCoE). FCoE allows the physical Ethernet
link to carry both Ethernet and Fibre Channel traffic.
On a Cisco Nexus 5000 Series switch, the Ethernet interfaces are enabled by default.
About the Interface Command
You can enable the various capabilities of the Ethernet interfaces on a per-interface basis using the interface
command. When you enter the interface command, you specify the following information:
• Interface type—All physical Ethernet interfaces use the ethernet keyword.
• Slot number
• Port number
Information About Ethernet Interfaces, page 11
Configuring Ethernet Interfaces, page 17
Displaying Interface Information, page 39
Default Physical Ethernet Settings , page 42
◦ Slot 1 includes all the fixed ports.
◦ Slot 2 includes the ports on the upper expansion module (if populated).
◦ Slot 3 includes the ports on the lower expansion module (if populated).
◦ Port number within the group.
Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.0(3)N1(1)
3
C H A P T E R
11
Advertisement
Table of Contents
