hit counter script

Vlans And Port Tagging; Configuration Task List; Creating A Port-Based Vlan - Dell S3048-ON Configuration Manual

Hide thumbs Also See for S3048-ON:
Table of Contents

Advertisement

VLANs and Port Tagging

To add an interface to a VLAN, the interface must be in Layer 2 mode. After you place an interface in Layer 2 mode, the interface is
automatically placed in the Default VLAN.
Dell Networking OS supports IEEE 802.1Q tagging at the interface level to filter traffic. When you enable tagging, a tag header is added to
the frame after the destination and source MAC addresses. That information is preserved as the frame moves through the network. The
following example shows the structure of a frame with a tag header. The VLAN ID is inserted in the tag header.
Figure 121. Tagged Frame Format
The tag header contains some key information that Dell Networking OS uses:
The VLAN protocol identifier identifies the frame as tagged according to the IEEE 802.1Q specifications (2 bytes).
Tag control information (TCI) includes the VLAN ID (2 bytes total). The VLAN ID can have 4,096 values, but two are reserved.
NOTE:
The insertion of the tag header into the Ethernet frame increases the size of the frame to more than the 1,518 bytes as
specified in the IEEE 802.3 standard. Some devices that are not compliant with IEEE 802.3 may not support the larger frame
size.
Information contained in the tag header allows the system to prioritize traffic and to forward information to ports associated with a specific
VLAN ID. Tagged interfaces can belong to multiple VLANs, while untagged interfaces can belong only to one VLAN.

Configuration Task List

This section contains the following VLAN configuration tasks.

Creating a Port-Based VLAN

Assigning Interfaces to a VLAN
Assigning an IP Address to a VLAN
Enabling Null VLAN as the Default VLAN
Creating a Port-Based VLAN
To configure a port-based VLAN, create the VLAN and then add physical interfaces or port channel (LAG) interfaces to the VLAN.
NOTE:
The Default VLAN (VLAN 1) is part of the system startup configuration and does not require
configuration.
A VLAN is active only if the VLAN contains interfaces and those interfaces are operationally up. As shown in the following example, VLAN 1
is inactive because it does not contain any interfaces. The other VLANs contain enabled interfaces and are active.
NOTE:
In a VLAN, the shutdown command stops Layer 3 (routed) traffic only. Layer 2 traffic continues to pass through the
VLAN. If the VLAN is not a routed VLAN (that is, configured with an IP address), the shutdown command has no affect on
VLAN traffic.
When you delete a VLAN (using the no interface vlan vlan-id command), any interfaces assigned to that VLAN are assigned to
the Default VLAN as untagged interfaces.
To create a port-based VLAN, use the following command.
(mandatory)
(optional)
(optional)
Virtual LANs (VLANs)
873

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save PDF