English DUST EXTRACTOR DCV586M Congratulations! You have chosen a D WALT dust extractor. Years of experience, thorough product development and innovation make D WALT one of the most reliable partners for professional power Markus Rompel tool users. Vice-President Engineering, PTE-Europa WALT, Richard-Klinger-Straße 11,...
English Specific Safety Rules for Dust Extractors If the supply cord is damaged, it must be replaced by a specially prepared cord available through the D WALT • The appliance may only be used by persons who are familiar service organisation. with it, have been trained on how to use it safely and who Mains Plug Replacement understand the resulting hazards.
English DO NOT attempt to charge the battery pack with any nOTE: To ensure maximum performance and life of lithium-ion • chargers other than the ones in this manual. The charger battery packs, charge the battery pack fully before first use. and battery pack are specifically designed to work together.
English an optimal depth leaving approximately 5.5 mm of the screw damaged in any way (i.e., pierced with a nail, hit with exposed. Align the slots on the back of the charger with the a hammer, stepped on). Electric shock or electrocution exposed screws and fully engage them in the slots.
3 batteries of 36 Wh each. The Use Wh rating might Battery Type indicate 108 Wh (1 battery implied). The DCV586M operates on a 54 volt battery pack. Storage Recommendations These battery packs may be used: DCB546, DCB547, DCB548. 1. The best storage place is one that is cool and dry away Refer to Technical Data for more information.
The dust extractor can be used with a D WALT TSTAK transport Pairing symbol. system or as a stand alone unit on the floor. The DCV586M is suitable for picking up dry and non-flammable Ø Ø dusts, liquids, wood chips, mineral dusts containing quartz and Hose diameter switch postions.
English Fuel Gauge Battery Packs (Fig. B) 4. Rotate the bag until the two tabs align with the two notches on the dust extractor and remove the bag from the Some D WALT battery packs include a fuel gauge which dust extractor.
Page 14
2. Press and hold the Wireless Tool Control pairing button remove the battery 7 on the DCV586M and pull the trigger on the Wireless Tool Control equipped tool or press the button on the remote 2. Unlatch tank latches and remove dust extractor head ...
Dispose of filter in appropriate container according to extractor on the bottom. statutory provisions. The DEWALT TSTAK stacking latches l allow for other To Install Filters (Fig. E, F, I) TSTAK products to securely stack one on top of the other for convenience and portability.
English Storage (Fig. A) WARNING: To reduce the risk of serious personal injury, turn dust extractor off and disconnect battery CAUTION: The three position switch must be in OFF (0) pack before making any adjustments or removing/ position to prevent unintentional being switched on by installing attachments or accessories and if the Wireless Tool Control.
English Fleece filter bag: The DCV9402 fleece bag is designed to capture many types of dust including drywall, concrete and wood. This bag should be disposed of once the airflow becomes restricted. DO NOT reuse this bag. The fleece bag is ideal for heavier materials such as concrete and drywall dust where a paper filter bag may tear.
English TROUBLESHOOTING Problem Possible Cause Troubleshooting steps Motor does not run. Switch is not in On (I) position. Ensure three position switch is in On (I) position. Low battery voltage/poor battery connection. Ensure battery is fully charged and fully inserted. Tank is full of liquid and sense circuit is tripped.
Page 20
Belgique et WALT - Belgium BVBA Tel: NL 32 15 47 37 63 www.dewalt.be Luxembourg België en Luxemburg Egide Walschaertsstraat 16 Tel: FR 32 15 47 37 64 enduser.BE@SBDinc.com 2800 Mechelen Fax: 32 15 47 37 99 Danmark WALT (Stanley Black&Decker AS)