Cisco DX70 Setting Up

Nhs networked use

Hide thumbs Also See for DX70:

Download this manual

Cisco DX70 or 80: Setting up for NHS networked use

Please contact

vc.support@nhs.net

4-digit PIN number to be used to unlock the screen. This is required for the final part of the

set-up.

Your DX

must

have a valid, unused, 10.247.*.* IP address (along with appropriate

gateway, subnet and DNS settings). If your board uses dedicated network ports for its

video conference devices (a specific VLAN) then you must attach your DX to one of these

network ports or ask for the one you intend using it on to be enabled for this purpose.

Once this is in place please connect the DX to your network and power it on.

N.B. We only allow video devices on this network address range. Your ability to use

Android apps will be disabled once your device has registered.

giving the MAC address of any system you wish to

If you are required to enter a static IP address for your network

you will probably see a screen saying you are unable to connect

to a network.

Tap Cancel

Tap Get Started

on the first Welcome Screen then

next screen.

At the top RHS of the screen you'll now see 6 small white dots.

v1.5

tap OK

on the

Page 1 Cisco DX70 or 80: Setting up for NHS networked use v1.5 Please contact vc.support@nhs.net giving the MAC address of any system you wish to register. The MAC address allows us to set your dial-in number correctly. You will be sent a 4-digit PIN number to be used to unlock the screen.
Page 2 Tap the dots (and OK again if you’re asked on the next screen) then tap Settings (round orange icon). Tap IPv4 configuration. Tick Use static IP (unless your board uses DHCP and NAT addressing). Enter your network details and tap Save On the left hand menu, still within Settings →...

Dx80