Related Manuals for NEC NP-90MS01
Summary of Contents for NEC NP-90MS01
- Page 1 Setting of IP address of Ether 0 and Ether 1 ① ② ③ ④ Input address and save After saved, reset IMS. ⑤ ⑥ After pushed reset, please wait about 5 minutes for lead time of changing IP address.
- Page 2 Device Manager setting When you use new NP-90MS01, you need to set Device manager. If you do not set Device manager, you can not use marriage function of the projector with NP-90MS01. ① Select Projector ② Fill same setting without IP address.
- Page 3 HDMI and SDI setting When you use HDMI and SDI, you need to set the device controller every time. GUI store the previouly setting after set the device controller in future. 1. First setting. Select DEVICE CONTROLLER ① Select Manual ②...
- Page 4 ⑤ Select input terminal. 2. Second setting. When you use the function without power off and log off, please use as follows; If you powered off the IMS, you need to set Device controller for '1. First setting'. ② IMSを選択...
- Page 5 Playback ① ② Select DCP...
- Page 6 ③ ④...
- Page 7 DO NOT use shutdown function of NP-90MS01. If you powered on the NP-90MS01, please power on the projector. When the projector is standby mode, the NP-90MS01 is not Power-on mode. So you can not log-in the GUI of NP-90MS01. ①...