Toro Greensmaster 3100 Quick Start Manual
Hide thumbs
Also See for Greensmaster 3100:
- Service manual (234 pages) ,
- Operator's manual (44 pages) ,
- Installation instructions (4 pages)
Advertisement
Quick Links
Weight Kit
Greensmaster
Three-Wheel Drive
Model No. 99-1645
This product contains a chemical or chemicals known to the State of California to
Note: Determine the left and right sides of the machine from the normal operating position.
Note: The rear tire may be removed from the castor fork for ease in hole drilling and installation of the weight kit.
The Greensmaster 3100, 3150 and 3250-D 3-Wheel Drive Traction Units equipped with ROPS, Spiker or Tri-Roller Kits
comply with ANSI B71.4-2012 and EN ISO 5395:2013 standards when they are equipped with this weight kit and 43 lb. of
calcium chloride ballast added to the rear wheel.
The Greensmaster Traction Unit 3250-D (Model 04384) equipped with ROPS, this weight kit, 18 kg (40 lb) of calcium
chloride ballast added to the rear wheel, three wheel drive kit, and cutting units, dethatchers, spikers, or tri-roller decks comply
with ANSI B71.4-2012 and EN ISO 5395:2013 standards.
Important: If a puncture occurs in a tire with calcium chloride, remove the unit from the turf area as quickly as
possible. To prevent possible damage to the turf, immediately soak the affected area with water.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Weight
Bolt
Locknut
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3100, 3150 or 3250-D Traction Unit with
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Qty.
2
6
6
Register at www.Toro.com.
Install the kit.
Original Instructions (EN)
All Rights Reserved *3405-783* A
Printed in the USA
Form No. 3405-783 Rev A
Installation Instructions
Use
Advertisement
Related Manuals for Toro Greensmaster 3100
Summary of Contents for Toro Greensmaster 3100
- Page 1 Note: The rear tire may be removed from the castor fork for ease in hole drilling and installation of the weight kit. The Greensmaster 3100, 3150 and 3250-D 3-Wheel Drive Traction Units equipped with ROPS, Spiker or Tri-Roller Kits comply with ANSI B71.4-2012 and EN ISO 5395:2013 standards when they are equipped with this weight kit and 43 lb. of calcium chloride ballast added to the rear wheel.
- Page 2 Installing the Kit on the Installing the Kit on the Greensmaster 3100 (Model Greensmaster 3200 (Model 04356) and 3150 (Models 04357 04380), 3200-D (Model 04381), and 04358) and 3250-D (Models 04383 and 04384) 1. Locate, mark, and drill 3 holes (13.5 mm [0.53 inch] diameter) on each side of the rear castor fork as shown 1.