Page 1
Gas hob EC9A5RB90A, EC9A5SB90A This cooktop is approved for use with Natural Gas and Universal LPG. Leave these instructions with the owner. USER INSTRUCTIONS INSTALLATION INSTRUCTIONS MAINTENANCE INSTRUCTIONS...
Warranty conditions ......17 Produktinfo Additional information on products, accessories, replacement parts and services can be found at www.siemens-home.bsh-group.com and in the online shop www.siemens-home.bsh-group.com/eshops...
Intended use lack of experience and knowledge, unless 8Intended use they have been given supervision or instruction concerning use of the appliance by R ead these instructions carefully. You will only a person responsible for their safety. Children I n t e n d e d u s e be able to use your appliance safely and should be supervised to ensure that they do effectively when you have read them.
Important safety information Warning – Risk of fire! (Important safety The cooking process must be supervised. A ■ information short cooking process must be supervised without interruption. The burners get very hot. Do not rest D O NOT MODIFY THIS APPLIANCE. Risk of fire! ■...
Installation and connection Preparing to install 5Installation and connection Refer to AS/NZS 5601.1 for piping size details. These built-in cooktops are intended to be inserted in a S tatutory requirements benchtop cutout. I n s t a l l a t i o n a n d c o n n e c t i o n This installation must conform with the following: Do not stick the cooktop onto the worktop with silicone.
Installation and connection Clearances Installation of cooktop into the kitchen bench A range hood fitted above the top must be installed according to the installation instructions for the range Side clearances: If the distance measured from the hood. A minimum distance of 650 mm is required for a periphery of the nearest burner to any vertical surface is range hood and 750 mm for an exhaust fan.
Installation and connection This appliance must be earthed. When connecting Fit regulator (N.G.) or a test point (Universal LPG) ■ the cooktop ensure that the earth wire is connected directly to the R 1/2’’ connection. first and that all wires are connected to the correct terminals.
Installation and connection Ignite all burners both individually and concurrently to Fasten the distributors and burner caps to the ensure correct operation of gas valves, burners and corresponding burners. In addition to this, put the ignition. Turn gas taps to low flame position and pan supports in place on the corresponding burners.
Getting to know your appliance Controls and burners *Getting to know your Each control knob is marked with the burner it controls. appliance You can use the control knobs to set the output required in each case to various positions between the maximum and the minimum settings.
Gas burners It is essential to ensure that all the burner parts and pan Simmer plate supports are correctly installed for the appliance to This accessory part is only suita- work correctly. Do not swap the burner caps around. ble for simmering. It can be Always remove the pan supports carefully.
Settings table and tips JSettings table and tips Warning – Risk of deflagration! If the flame does not ignite after 15 seconds, switch off the burner and open a window or the door to the room. S uitable pans Wait at least one minute before switching the burner on S e t t i n g s t a b l e a n d t i p s again.
Settings table and tips Pans should be placed on Example: the hob carefully. Meal Total Step 1 Step 2 Do not strike the hob and time in do not place excessive Burner ˜ § v ˜ § v weight on it. min.
Page 13
Settings table and tips Food Total Step 1 Step 2 Food Total Step 1 Step 2 time in time in Burner Burner ˜ § v ˜ § v ˜ § v ˜ § v min. min. Standard-out- 20-24 10-12 10-12 High-output ›...
Page 14
Settings table and tips Food Total Step 1 Step 2 Food Total Step 1 Step 2 time in time in Burner Burner ˜ § v ˜ § v ˜ § v ˜ § v min. min. Carbonara sauce Minced meat Standard-out- 10-15 High-output...
Page 15
Settings table and tips Cooking tips Food Total Step 1 Step 2 Use a pressure cooker to cook creamy soups and time in ■ Burner ˜ § v ˜ § v pulses. This significantly reduces the cooking time. If min. you are using a pressure cooker, follow the manufacturer's instructions.
Cleaning and maintenance Do not use steam cleaners. This could damage the 2Cleaning and maintenance ■ hob. If your hob is fitted with a glass or aluminium panel, ■ never use a knife, scraper or similar implement to C leaning C l e a n i n g a n d m a i n t e n a n c e clean the point where it joins the metal.
Customer service Fault Possible cause Solution The kitchen smells of gas. A gas tap has been left on. Turn off the taps. Incorrect coupling of gas cylinder. Check that the coupling is sound. Possible gas leak. Shut off the gas supply, ventilate the premises and imme- diately notify an authorised installation technician to check and certify the installation.
Page 20
BSH Hausgeräte GmbH Carl-Wery-Straße 34 81739 München, GERMANY siemens-home.bsh-group.com Manufactured by BSH Hausgeräte GmbH under the trademark licence of Siemens AG *8001262285* 9001226692 (021104)