Rated Voltage 220-240V Rated Power Frequency 50Hz Light Power 2x1W Motor Power 250W Total Power 252W Maximum suction 1200m Diameter of Exhaust Pipe 170mm Product Dimension (mm) L 900 x W 484 x H 530-1005(AKR5100/IX), Net Weight/ Gross Weight 18.5kg/23kg (AKR5100/IX)...
Page 3
Important Safety Information 1. Always disconnect the hood from the power supply before carrying out any installation or maintenance operation on the appliance. 2. Installation must be carried out by a specialised technician, incompliance with the manufacturer’s instructions and local safety regulations. 3.
Page 4
22. If the hood is used together with other appliances operating on gas or other fuels, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar). Therefore, make sure the room is adequately ventilated. 23. Do not leave pans unattended when frying, since the cooking oil could catch fire. 24.
GENERAL RECOMMENDATIONS Before use Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage. During use To avoid any damage do not place any weights on the appliance. Do not expose the appliance to atmospheric agents. This is a heavy product;...
Fig 2 Fig 3 Fitting the Chimney 1. Arrange the electrical power supply inside the chimney. 2. Adjust the width of the support bracket of the exterior chimney (Fig.3). Then fix it to the ceiling using the screws A (Fig.2) make sure that it is in line with your hood and respecting the distance from the ceiling indicated in Fig.2.
Page 10
2. Fix the pipe in position using 2 screws from two sides of the air outlet adapter. Maker sure the pipe is secured. REMARKS 1. A straight, short pipe will allow the hood to perform efficiently 2. Long duct, elbows and transitions will reduce performance of the hood. Use as few as possible. Bigger pipe may need when using long duct.
Page 11
Maintence Make sure appliance is switch off or unplug before carrying out any maintenance work. Grease Filter 1. The filters are washable at least every 2 months of operation, or more frequently for particularly heavy usage. 2. Remove the filter one at a time by supporting them with one hand and push the lock to release the filter 3.
Page 12
Hood and Hob is too high Filter is choked Clean filter and refit in its place Duct is damaged Call consumer service for support Whirlpool Hong Kong Ltd. 17/F., Elite Centre, 22 Hung To Road Kwun Tong, Kowloon, H.K.