Safety instructions Children must not play with, on, Delivery or around the appliance. 1. Check the packaging and Children must not clean the dishwasher immediately for appliance or carry out general damage caused in transit. Do maintenance unless they are at not switch on a damaged least 8 years old and are being appliance, but contact your...
Page 6
Safety instructions The electrical connection If you cannot obtain any conditions must correspond information from with the specifications the manufacturer, you must on the dishwasher rating not install the dishwasher plate 9B. above or below these appliances. If the power cord of this appliance is damaged, If you install a microwave it must be replaced with...
Safety instructions In daily use Deactivating the button lock: Hold down the button + for Read and observe the safety information and instructions approx. 4 sec. until the for use on the packaging display goes out. for cleaning and rinsing agents. When the programme ends on the digital display), the Childproof lock (door lock)
Page 8
Safety instructions Warning Warning Risk of injury! Risk of explosion! Do not add any solvents To prevent injuries, e.g. to the washing chamber. caused by stumbling, open Danger of explosion! the dishwasher only briefly in order to load and unload Warning the dishwasher.
Protection of the environment Keep children away from Protection of the open dishwasher. There may environment be small parts in the dishwasher which children i o n P r o t e c t o f t e n v i r o n m e n t could swallow and the water Both the packaging of new appliances and the old appliances themselves...
Getting to know your appliance Appliance interior Getting to know your appliance 1" Interior light * G e t t i t o k n o w y o u r a p p l i a n c 1* Cutlery drawer Diagrams of the control panel 12 Top basket and the interior of the appliance can be...
Water softening system/Special salt To change the setting: Water softening 1. Press programme button 3. system/Special salt Each time the button is pressed, the set value increases by one level; W a t e r s o f t e n i s y s t e m / S p e c i s a l t when the value of :...
Rinse aid Using special salt Switching off salt refill indicator/water softening Always refill with special salt system immediately before switching on the S w i t c h i n g o f f w a t e r s o f t e n i n g s y s t e m appliance.
Rinse aid 1. Open the dispenser 9* by pressing Setting amount of rinse aid and lifting the plate on the cover. The amount of rinse aid can be set from to : . Please set rinse aid on to obtain very good drying results is already set in factory).
Utensils Loading the dishwasher Utensils U t e n s i 1. Remove large food remnants. It is not necessary to prerinse utensils Not suitable under running water. 2. Place the utensils so that Cutlery and utensils made of wood. –...
Utensils Cups and glasses Pans Top basket 12 Bottom basket 9" Note Utensils must not be placed above the Heavily soiled utensils (pans) should tablet collecting tray 1B. These may be placed in the bottom basket. The block the lid of the detergent dispenser more powerful spray jet provides and prevent it from opening fully.
Utensils Cutlery drawer F olding spikes * F o l d i n g s p i k e s Arrange the cutlery in the cutlery drawer * depending on model 1* as illustrated. Separately arranged The spikes can be folded down to utensils are easier to remove after improve arrangement of pans, bowls washing.
Detergent Adjusting the height of the 3. To raise the basket, hold the basket on the sides of the upper edge and basket lift it up. 4. Before re-inserting the basket again, The height of the upper utensils basket ensure that it is at the same height 12 can be adjusted in 3 stages to on both sides.
Detergent Adding detergent 2. Close the cover on the detergent dispenser by sliding it up until the lock engages without difficulty. 1. If the detergent dispenser 92 is still closed, press the lock 9: to open the detergent dispenser. Pour detergent into the dry detergent dispenser 92 only (insert tablet flat, not on its edge).
Detergent Combination detergent Notes You will obtain optimum rinsing Apart from conventional detergents and drying results by using solo (Solo), a number of products are offered detergents and applying salt with additional functions. These and rinse aid separately. products contain not only the detergent If programmes are short, tablets but also rinse-aid and salt replacement may not have full cleaning effect...
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
Additional options § Programme selection Half load * H a l f l o a d You can select a suitable programme If you have only a few items to wash according to the type of utensils and (e.g. glasses, cups, plates), you can degree of soiling.
Operating the appliance Zeolith drying Operating the appliance The appliance features a Zeolith container Zeolith is a mineral which can O p e r a t i i a n c e t h e a p p l store moisture and heat energy and release them again.
Operating the appliance Switching on the appliance Remaining running time display 1. Turn on the tap fully. 2. Switch on ON/OFF switch (. When the programme is selected, the remaining running time of the The Eco 50° programme display programme is indicated on the digital flashes.
Operating the appliance Automatic switch off after end To change the setting: 1. Press programme button 3. of programme or interior light* A u t o m a t i c s w i t c h o f f / i n t e r i o r l i g h t Each time the button is pressed, the set value increases by one level;...
Cleaning and maintenance T erminating the programme To change the setting, T e r m i n a t i n g t h e p r o g r a m m e 1. Press the button 3 to switch the (Reset) Intensive drying on : or off :...
Cleaning and maintenance Never use a steam cleaner to clean your Filters dishwasher. The manufacturer is not liable for any consequential damage. The filters 1j keep large foreign Regularly wipe the front of the appliance objects in the rinsing water away from and fascia with a damp cloth;...
Fault, what to do? Spray arms Fault, what to do? F a u l t , w h a t d o ? Limescale and contaminants in the rinsing water may block nozzles and Experience has shown that you can bearings on the spray arms 1: and rectify most faults which occur in daily operation yourself.
Fault, what to do? Waste water pump 6. Check impeller wheel and remove any foreign objects. 7. Place cover in the original position Large food remnants or foreign objects and press down until it engages which were not captured by the filters (click).
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display 8 lights up. Tap turned off. Turn the tap on. Tap jammed or calcified. Turn the tap on. Flow rate must be min.
Page 30
Fault, what to do? Fault Cause Remedial action Error code : is lit. Waste water pump blocked or Clean pump and lock cover correctly. (See cover on the waste water pump is “Waste water pump”) not locked in position. Error code : is lit.
Page 31
Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid in the Refill rinse aid. dispenser. Programme selected without Select programme with drying (see drying. “Overview of programmes”, “Programme sequence”). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
Page 32
Fault, what to do? Fault Cause Remedial action Food remnants on the Utensils placed too closely Arrange utensils with adequate clearance utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
Page 33
Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts. surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
Page 34
Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting of Can be partly removed with machine brown), difficult to remove ingredients from vegetables (e.g. cleaner or by mechanical cleaning. Coatings to non-removable coatings cabbage, celery, potatoes, are harmless.
Page 35
Fault, what to do? Fault Cause Remedial action Initial or existing, Glasses not dishwasher-proof, Use dishwasher-proof glasses. irreversible clouding of only suitable for dishwasher. Avoid long steam phase (standing time after glass. wash cycle ends). Use wash cycle at lower temperature. Set water softening system according to the water hardness (if required one setting lower).
Page 36
Fault, what to do? Fault Cause Remedial action Detergent residue in the Spray arms blocked by utensils, Ensure that the spray arms can rotate freely. detergent dispenser or in therefore detergent is not rinsed the tablet collecting tray. out. The detergent dispenser was Pour detergent into the dry detergent damp when filled.
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service.
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains.
Installation and connection Drinking water connection Setting hot water: 1. Close the door. 2. Switch on ON/OFF switch (. 1. Fasten the drinking water connection to the tap according 3. Hold down programme button # to the installation instructions using and press START button h the enclosed parts.
Installation and connection The connection may be modified by Transportation technicians only. A power cord extension may be Empty the dishwasher and secure loose purchased from customer service parts. only. Drain the appliance according to the Use only a residual current operated following steps: circuit-breaker which features 1.
Page 42
*9001013109* 9001013109 en (9509) 640MG...