Advertisement
Available languages
Available languages
Quick Links
Installation
Instructions
If you have questions, call GE Appliances at 800.GE.CARES (800.432.2737) or Visit our Website at:
GEAppliances.com.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IN THE COMMONWEALTH OF
MASSACHUSETTS:
This product must be installed by a licensed
plumber or gas fitter.
When using ball-type gas shut-off valves, they shall
be the T-handle type.
A flexible gas connector, when used, must not
exceed 3 feet.
IMPORTANT
for local inspector's use.
IMPORTANT
codes and ordinances.
IMPORTANT
appliance shall be conducted according to the
manufacturer's instructions.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these instructions for
future reference.
Skill level – Installation of this appliance requires
basic mechanical skills.
Completion time – 1 to 3 hours
Proper installation is the responsibility of the
installer.
Product failure due to improper installation is not
covered under the Warranty.
WARNING
This appliance must be properly
grounded.
31-2000792 Rev. 0 07-20
— Save these instructions
— Observe all governing
— Leak testing of the
24" Gas Built-In Oven
JGRP20
FOR YOUR SAFETY
WARNING
not followed exactly, a fire, explosion or gas leak may
result, causing property damage, personal injury or
death.
DO NOT STORE OR USE GASOLINE OR OTHER
FLAMMABLE VAPORS AND LIQUIDS IN THE
VICINITY OF THIS OR ANY OTHER APPLIANCE!
WHAT TO DO IF YOU
SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any
phone in your building.
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
If you cannot reach your gas supplier, call the fire
department.
Installation and service must be performed by a
qualified installer, service agency or the gas supplier.
Be sure your oven is installed properly by a
qualified installer or service technician.
Be sure the oven is securely installed in a cabinet
that is firmly attached to the house structure.
Weight on the oven door could cause the oven to
tip, resulting in serious personal injury or death.
Never allow anyone to climb, sit,
If the information in this manual is
1
Advertisement
Related Manuals for GE JGRP20WEJWWGE
Summary of Contents for GE JGRP20WEJWWGE
- Page 1 Installation 24” Gas Built-In Oven Instructions JGRP20 If you have questions, call GE Appliances at 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com. BEFORE YOU BEGIN FOR YOUR SAFETY WARNING Read these instructions completely and carefully. If the information in this manual is...
-
Page 2: Installation Preparation
Installation Preparation TOOLS YOU WILL NEED GAS REQUIREMENTS You must follow local codes when installing your built-in oven. Check with your local utilities for codes and ordinances that apply in your area. If there are no local codes, you must follow the Safety Glasses National Fuel Gas Code ANSI/Z223.1 –... - Page 3 Installation Preparation The cabinet must have solid sides, back and 3 PREPARE THE OPENING bottom. The bottom must be solid either at floor level or with the bottom edge of the cutout. Any openings around the gas or electrical outlets must be sealed. All cabinet openings must be sealed at the time of installation to prevent drafts.
-
Page 4: Installation Instructions
Installation Instructions INSTALL THE OVEN ELECTRICAL CONNECTIONS GAS CONNECTIONS An adequate electrical supply and outlet must be used WARNING to operate the electrical parts of your oven. Do not operate the burners of this oven when using LP (bottled) gas before A. - Page 5 Installation Instructions GAS CONNECTIONS (Cont.) CHECK FOR LEAKS I. Place the oven in the cutout. WARNING J. Level the oven: DO NOT USE OPEN FLAME TO CHECK FOR LEAKS! 1. Place a spirit level on one of the oven racks. A.
- Page 6 Installation Instructions INSTALL THE OVEN (Cont.) CHECK THE BURNER FLAMES FOR MAKE THE BURNER FLAME NATURAL GAS ADJUSTMENTS (Cont.) The oven is factory-adjusted for use with Natural Gas E. Use a screwdriver to loosen the air shutter screw. in most areas. But, since the gas in some areas may 1.
- Page 7 Installation Instructions SECURE THE OVEN RECHECK STEPS Double check to make sure everything in this guide has IMPORTANT: Remove all packing been completed. Rechecking steps will ensure safe material and literature from the oven use of the oven. before connecting any electrical supplies. WARNING A.
- Page 8 Installation Instructions MAKE THE LP GAS CONVERSION WARNING ADJUST PRESSURE REGULATOR If you are using LP (bottled) gas, FROM NATURAL GAS TO LP all the adjustments described below must be made (Cont.) before you make any burner adjustments or use the oven.
- Page 9 Installation Instructions FOR BAKE AND BROIL BURNERS ADJUST AIR SHUTTER Use a 1/2” open end or adjustable wrench to turn the NOTE: The Bake and Broil burner flame must be orifice hood in the LP direction, about 1-1/2 turns, until checked with the door closed to properly check flame snug.
- Page 10 Installation Instructions MAKE THE LP GAS CONVERSION (Cont.) ADJUST AIR SHUTTER (Cont.) ADJUST AIR SHUTTER (Cont.) BAKE BURNER BROIL BURNER Air Shutter A. The broil burner is located and accessible in the top Orifice rear of the oven. Fitting Cover B.
-
Page 11: Instrucciones De Instalación
Horno A Gas Instrucciones Empotrado de 24” de Instalación JGRP20 ¿Preguntas? Llame al 1.800.GE.CARES (800.432.2737) o bien visite nuestra página Web: GEAppliances.com ANTES DE EMPEZAR: PARA SU SEGURIDAD: ADVERTENCIA Lea estas instrucciones y las advertencias Si la información en este manual completa y cuidadosamente. - Page 12 Preparación de Instalación LISTA DE HERRAMIENTAS REQUERIMIENTOS DE GAS Usted debe cumplir con los códigos locales cuando instale su horno. Consulte con su compañía de gas local acerca de las leyes y ordenanzas locales que se aplican en su área. Si no existen códigos locales, Gafas de seguridad usted debe cumplir con el National Fuel Gas Code ANSI/Z223.1 –...
- Page 13 Instrucciones de Instalación El gabinete debe tener fondo, posterior y lados 3 PREPARE LA ABERTURA sólidos. El fondo debe ser sólido, a nivel del piso o con el borde sólido del fondo del corte. Todas las aberturas del gabinete deben estar selladas en el momento de la instalación para prevenir corrientes de aire.
-
Page 14: Instalación Del Horno
Instrucciones de Instalación INSTALACIÓN DEL HORNO CONEXIONES ELÉCTRICAS CONEXIONES DEL GAS Un abastecimiento y receptáculo eléctrico adecuado debe ser ADVERTENCIA usado para operar las partes eléctricas de su horno. No haga funcionar los quemadores de este horno cuando use gas LP (embotellado) antes A. - Page 15 Instrucciones de Instalación INSTALACIÓN DEL HORNO (Cont.) CONEXIONES DEL GAS (Cont.) REVISE QUE NO HAYAN ESCAPES I. Coloque el horno en el corte. ADVERTENCIA ¡NO USE UNA LLAMA ABIERTA J. Nivele el horno: PARA VER SI EXISTEN ESCAPES DE GAS! 1.
- Page 16 Instrucciones de Instalación INSTALACIÓN DEL HORNO (Cont.) CÓMO REVISAR LAS LLAMAS DE CÓMO AJUSTAR LAS LLAMAS DEL LOS QUEMADORES A GAS QUEMADOR (Cont.) NATURAL E. Use un destornillador para soltar el tornillo del obturador de aire. El horno viene ajustado de fábrica para ser usado con gas 1.
- Page 17 Instrucciones de Instalación INSTALACIÓN DEL HORNO (Cont.) CÓMO COLOCAR BIEN EL HORNO REVISE LOS PASOS Revise varias veces para asegurarse que todo en esta guía IMPORTANTE: Saque todos los materiales ha sido completado. El revisar los pasos le asegurará la de empaque y la literature del horno antes de utilización segura del horno.
- Page 18 Instrucciones de Instalación CÓMO HACER LA CONVERSIÓN PARA GAS LP ADVERTENCIA AJUSTE EL REGULADOR DE Si usted va a usar gas LP PRESIÓN DE GAS NATURAL A (embotellado), todos los ajustes descritos más abajo deben hacer antes de hacer cualquier ajuste a los GAS LP(Cont.) quemadores o usar el horno.
- Page 19 Instrucciones de Instalación CÓMO HACER LA CONVERSIÓN PARA GAS LP (Cont.) PARA QUEMADORES PARA AJUSTE EL OBTURADOR DE HORNEAR Y ASAR AIRE NOTA: Las llamas para hornear y asar se deberían revisar la tapa del orificio en dirección de LP, aprox. 1 1/2 vuelta, con la puerta cerrada para revisar correctamente las hasta que quede apretada.
- Page 20 Instrucciones de Instalación CÓMO HACER LA CONVERSIÓN PARA GAS LP (Cont.) AJUSTE EL OBTURADOR DE AIRE AJUSTE EL OBTURADOR DE (Cont.) AIRE (Cont.) QUEMADOR PARA HORNEAR QUEMADOR PARA ASAR A. El quemador para asar está ubicado y es accesible en la Obturador de Aire Cubierta...