Table of Contents
Advertisement
Chapter 4. Removing a FRU or CRU
Service tools
The following table lists tools for servicing Lenovo computers. Tools with a cross mark are needed for serving
the product models as described by this publication. Prepare them before you service the product.
Table 3. Service tools
Service tool and consumable
Screw driver (Phillips head) (PH1/PH0)
Screw driver (Torx head) (T5)
Screw driver (Torx head) (T30)
Pry tool 1
Tweezers (conductive)
Tweezers (isolated)
Suction cup
Hexagonal socket
Silicone grease
Acetate tape
Polyamide tape
Mylar tape
Electrical tape
Double-sided tape
Conductive tape
Eraser
Heat gun
Brown brush
Notes:
• T30 screw drivers are used to service the new Intel Xeon CPUs.
• Hexagonal sockets are used to remove antenna connectors.
• Silicone grease is applied to the CPU and heatsink surfaces to eliminate air gaps.
General guidelines
When removing or replacing a FRU, ensure that you observe the following general guidelines:
1. Do not try to service any device unless you have been trained and certified. An untrained person runs the
risk of damaging parts.
2. Begin by removing any FRUs that have to be removed before replacing the failing FRU. Any such FRUs
are listed at the beginning of each FRU replacement procedure. Remove them in the order in which they
are listed.
© Copyright Lenovo 2023
Model applicability
X
X
X
X
X
25
Advertisement
Table of Contents
