Related Manuals for UFO IP-01
Summary of Contents for UFO IP-01
- Page 1 PRODUCT USER GUIDE IP-01 Weatherproof Enclosure Rev: C1 PLEASE READ THIS USER GUIDE BEFORE INSTALLING OPERATING OR PERFORMING MAINTENANCE ON THE ENCLOSURE...
- Page 2 INTRODUCTION Thank you for purchasing this UFO weatherproof enclosure which is fitted with an LED light source unit. To ensure the enclosure is mounted and connected correctly please read this user guide before installing and operating or performing any maintenance on the enclosure. To ensure that the...
-
Page 3: Model Variations
DC supply to a terminal block inside the enclosure. For this version, the PSU can be supplied by UFO or the customer. For the USA and Canada, if supplied by the customer the PSU must be UL listed and not only suitable in terms of correct voltage and wattage but also suitable for the environment/location in which the PSU is to be installed. - Page 4 INTRODUCTION FIGURE 2 AC POWERED VARIANT 01 WEATHERPROOF ENCLOSURE USER GUIDE...
-
Page 5: Model Information
INTRODUCTION MODEL INFORMATION Ordering Code Light Source Model Power Variant Max Wattage UFO IP01MIC1000AC MicroLED 1000 240VAC 50Hz UFO IP01MIC1000DC MicroLED 1000 12V DC UFO IP01MIC4000AC MicroLED 4000 240VAC 50Hz UFO IP01MIC4000DC MicroLED 4000 12V DC DIMENSIONS Note that dimensions are shown in mm. -
Page 6: Installation
300mm (12”) of space around all sides to allow for air circulation and to prevent overheating. Mounting the enclosure in any other way will invalidate the IP rating and the product warranty. UFO will accept no responsibility for any loss or damage that occurs due to incorrect mounting. 01 WEATHERPROOF ENCLOSURE USER GUIDE... - Page 7 3. Choose appropriate fixings for the surface that the enclosure is being mounted to. Note that unless UFO are installing the unit then we do not supply fixings. This is due to the large variance of surface types the enclosure may be mounted to.
- Page 8 INSTALLATION FOR DIRECT MAINS OPERATION ( AC SUFFIX MODELS ) CONNECTION There may up to three connections required via the appropriate gland: 1. The fibre harness. 2. The DMX cables for the MicroLED 4000 when configured as Master/Slave 3. Mains supply cable. The fibre harness should be connected first.
- Page 9 (AC version) or the remote PSU (DC version). If no light is produced consult the TROUBLESHOOTING section in this manual and the light source manual. UFO LIGHTING...
-
Page 10: Maintenance
Check fuse/trip & replace/reset if necessary. If Blown fuse or circuit tripped PSU is out problem persists, isolate mains and contact UFO Refer to Troubleshooting section in AC & DC enclosure Light source not connected correctly light source user guide model. -
Page 11: Technical Information
* Note that the IP protection category only applies when the enclosure is mounted as specified by UFO - see page 2 for details. Mounting the enclosure in any other way invalidates the IP rating and the product warranty. UFO will accept no responsibility for any loss or damage that occurs due to incorrect mounting. - Page 12 United Kingdom • United States • Germany • Europe • Universal Fibre Optics Ltd Universal Fiber Optics USA LLC UFO Licht GmbH Home Place Coldstream 1749 Northgate Blvd Andreasstraße 20 TD12 4DT Sarasota FL34234 93059 Regensburg Deutschland +44 (0)1890 883416...