Page 4
Fig. C Fig. D Fig. E Fig. F Fig.G Fig. H Fig. I...
Page 5
English HEAVY-DUTY CORDLESS MATERIAL DISPENSER DCE560, DCE571, DCE580, DCE581 Congratulations! You have chosen a D WALT tool. Years of experience, thorough product development and innovation make D WALT one of the most reliable partners for professional power tool users. Technical Data...
Page 7
English e ) Do not overreach. Keep proper footing and balance Shorting the battery terminals together may cause burns at all times. This enables better control of the power tool or a fire. in unexpected situations. d ) Under abusive conditions, liquid may be ejected f ) Dress properly.
Page 8
English NOTICE: Under certain conditions, with the charger Electrical Safety plugged into the power supply, the exposed charging The electric motor has been designed for one voltage only. contacts inside the charger can be shorted by foreign Always check that the battery pack voltage corresponds to the material.
Page 9
English Wall Mounting 14 2. Insert the battery pack into the charger, making sure the battery pack is fully seated in the charger. The red (charging) These chargers are designed to be wall mountable or to sit light will blink repeatedly indicating that the charging upright on a table or work surface.
Page 10
English Contents of opened battery cells may cause respiratory • The information provided in this section of the manual is irritation. Provide fresh air. If symptoms persists, seek provided in good faith and believed to be accurate at the time medical attention.
Page 11
Poker Mounting collar Battery Type LED worklight The DCE560, DCE571, DCE580 and DCE581 operate on a 18 volt Sausage holder (DCE571, DCE580 and DCE581) battery pack. Nozzle cap (DCE571, DCE580 and DCE581) These battery packs may be used: DCB181, DCB182, DCB183, Battery pack DCB183B, DCB184, DCB184B, DCB185, DCB546.
Page 12
In addition to the variable speed dial, the material's rate of flow and end-user application. is also controlled with a variable speed trigger. The DCE560, DCE571, DCE580 and DCE581 cordless material 1 1. Squeeze the trigger switch to turn the tool on.
Page 13
English iMPORTAnT: DO nOT remove caulk/material material Plunger Rod Handle (Fig. A) from the casing. nEVER dip the nozzle tip into any type WARNING: To reduce the risk of serious personal of material. injury, DO NOT use the plunger rod handle as a hook to 5.
Page 14
English Optional Accessories WARNING: Since accessories, other than those offered by D WALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only D WALT recommended accessories should be used with this product.