Internal cleaning Periodic cleaning When the appliance is not in use Something not Working? Service and Spare Parts Customer Care Departments Guarantee Conditions Electrolux Service Force Instructions for the Installer Technical Specifications Installation Positioning Electrical Connection Building-in instructions Door Reversal...
Do not place carbonated or fizzy drinks in the freezer compartment. Ice lollies can cause ‘frost/freezer burns’ if con- sumed straight from the star compartement. Do not remove items from the freezer comparte- ment if your hands are damp/wet, as this could cause skin abrasions or frost/freezer burns.
DESCRIPTION OF THE APPLIANCE Freezer calendar Freezer control Compartment for frozen food storage Compartment for freezing fresh food Thermometer OPERATION Before use Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or deter- gent as the smell may linger.
After the time has elapsed place the food to be frozen in the two top compartments of the freezer as this is the coldest part; if freezing only a small amount of food, always use the top compart- ment.
The following tips should help you to ensure that the food in your home is in as perfect condition as possible. Keep the freezer door closed as much as possi- ble. Do not push food together too much, try to allow air to circulate around each item.
Important In the event of a power failure causing the temperature within your freezer to rise, do not re-freeze the food without checking its condition. The following guidelines should assist you: Ice-cream: once thawed should be discard- Fruits &...
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELEC- TRICITY supply. Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water).
Symptom No power to the appliance The temperature in the freezer is too high The freezer door will not open The compressor runs continuously Excessive frost and ice has built up.
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Electrolux Service Force Centre by telephoning: 0870 5 929929 Your telephone call will be automatically routed to the Service Centre covering your post code area.
Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: The appliance has been correctly installed and used only on the electricity supply stated on the rating plate.
TECHNICAL SPECIFICATIONS DIMENSIONS POWER SUPPLY VOLTAGE AND FREQUENCY TOTAL POWER ABSORBED AVERAGE DAILY UNITS ELECTRICITY(*) GROSS CAPACITY NET CAPACITY STAR RATING (*)This figure is based on standard test results in accordance with European Standard EN153. Actual con- sumption will depend on how the appliance is used and where it is located. INSTALLATION Positioning For this appliance to work efficiently, it should be...
The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover/carrier must be obtained from your local Electrolux Service Force Centre. This appliance complies with the E.E.C. Directive No. 87/308 of 2.6.87 relative to radio interference suppression.
BUILDING-IN INSTRUCTIONS Before carrying out any work, remove the plug from the power socket. Door Reversal Left door opening: 1. Remove the grid from the appliance pulling it towards you with hands. 2. Remove the left side (A) of the grid cutting it from the rear (see figure).
Page 17
To reverse the opening direction of the door, proceed as shown in the figures: Attention After completion of the door reversing opera- tion, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet.
Building the appliance in under a worktop The dimensions of the recessed installation area must correspond with those indicated in the figure. DO013 Remove covering and adjusting strips. Push the appliance into place. The plug socket neces- sary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess.
Page 19
To mount the furniture door proceed as shown in the figures:...
Page 20
Screw appliance into place. Refit the covering strip.
Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm.