Replacing The Microprocessor - Lenovo ThinkCentre M81 Hardware Maintenance Manual
Hardware maintenance manual
Hide thumbs
Also See for ThinkCentre M81:
- (154 pages) ,
- Manual d'utilisation (148 pages) ,
- Manual do utilizador (148 pages)
Table of Contents
Advertisement
11. Lower and position the heat sink fan duct on the top of the heat sink and fan assembly until the two
screw holes in the heat sink fan duct are aligned with those in the heat sink and fan assembly. Install
the two screws to secure the heat sink fan duct.
Figure 84. Installing the heat sink fan duct
12. To complete the installation or replacement, go to "Completing the parts replacement" on page 160.
Replacing the microprocessor
Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre User Guide. To obtain a copy of the ThinkCentre User Guide, go to:
http://www.lenovo.com/ThinkCentreUserGuides
This section provides instructions on how to replace the microprocessor.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before removing the computer cover.
To replace the microprocessor, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Open the computer cover. See "Opening the computer cover" on page 121.
Chapter 9
.
Replacing FRUs (Machine Types: 0267, 0385, 1981, 4167, 5025, 5032, 5049, 5070, and 7518)
147
- Quick Links:
- For Machine Types: 0267, 0385, 1981,...
Hide quick links:
Advertisement
Table of Contents
