** Ink thaws and is usable after approximately 3 hours at 77 °F (25 °C). Caution: To ensure good results, use genuine EPSON cartridges and do not refill them. Other products may cause damage to your printer not covered by EPSON’s warranties.
Page 3
Always load paper into the sheet feeder short edge first. Load envelopes flap edge left with the flap side down. Since the quality of any particular brand or type of paper may be changed by the manufacturer at any time, EPSON cannot attest to the quality of any non-EPSON brand or type of paper.
Turn the printer back on. If the lights are still on, contact your dealer or EPSON as described on your Start Here sheet. The printer may have an internal error. Turn off the printer, wait a few seconds, and turn it on again.
The green P power light flashes as your printer charges ink for several seconds. Caution: Don’t turn off the printer while the green P power light is flashing, unless the printer hasn’t moved or made noise for more than 5 minutes.
❏ Load letterhead or preprinted paper into the printer top edge first. ❏ If you’re using special media, follow the instructions that came with the media. ❏ You can load the following number of sheets of EPSON special media: Paper type Premium Bright White Paper...
Page 7
1. Turn on the printer. 2. Lower the printer’s output tray, pull out the extension, and open the cover. 3. Press and release the H ink button. The print head moves to the left, and the cartridge that needs to be replaced stops under the _ ink out mark.
P power light stops flashing and stays on, and the red H ink light goes out. Caution: Never turn off the printer while the P power light is flashing, unless the printer hasn’t moved or made noise for more than 5 minutes. Cleaning the Print Head If your printouts are unexpectedly light, or dots or lines are missing, you may need to clean the print head.
If every pair of horizontal bars has a light or dark band between them, choose the one that looks the best. Then click to print another test page and repeat Realignment this step. , repeat steps 7 through 10. Next When you are finished, click Finish EPSON Stylus C64 to print...
3. If the outer case or inside of the sheet feeder is dirty, clean it with a soft cloth dampened with a mild detergent. Keep the printer cover closed to prevent water from getting inside. 4. If ink accidentally gets inside the printer, wipe it off with a damp cloth. Clean...
Caution: Be sure to remove the tape after installing the printer in its new location. 10. Close the printer cover, push in the output tray extension, then close the output tray. 11. Repack the printer and its attachments in the original box using the protective materials that came with them.