Imp¢ Features ata Glance.. Before Setting Oven Before Setting Surface Settinc Oven Control Functions www.frigidaire.ca Canada 1-800-_ www frigidaire.corn USA 1-800-944-9044...
17-18 Product Registration Care & Cleaning ..........19=22 Registering your product with Frigidaire enhances our ability Cleaning recommendation table ........ to serve you. You can register online at Surface elements and drip bowls ......w_,frigidaire,com or by dropping your Product Cautions for aluminum use ........
Read all instructions before using this appliance, Do not attempt to install or operate your appliance until you Ask your dealer to recommend a qualified technician and have read the safety precautions in this manual. Safety an authorized repair service. Know how to disconnect the items throughout this manual are labeled with a WARNING power to the range at the circuit breaker or fuse box in or CAUTION statement based on the risk type.
Page 4
= Do not use water or flour on grease fires= smother the fire with a pan lid, or use baking soda, = Storage in or on appliance--flammable materials a dry chemical or foam=type extinguisher. should not be stored in an oven, warmer drawer, near surface units or in the storage = When heating fat or grease, watch it closely.
Page 5
SELF-CLEANING OVENS IMPORTANT INSTRUCTIONS USING • Clean in the self=cleaning cycle only the parts YOUR COOKTOP listed in this Use &Care Manual. Before self-cleaning = Know which knob controls each surface heating the oven, remove the broiler pan and any utensils or unit.Place a pan of food on the unit before turning it on, foods from the oven.
Oven vent location The oven vent is located under the left rear surface element (See Fig. 1). When the oven is on, warm air passes through the vent. This venting is necessary for Always use oven mitts when using the oven. When proper air drculation in the oven and good baking results.
Air circulation in the oven Baking layer cakes with 1 or 2 oven racks For best baking results allow 2-4" (5-10 cm) around the For best results when baking cakes using 2 flat oven racks, cookware for proper air circulation and be sure pans and place cookware on rack positions 2 &...
Cookware material types Home Canning The cookware material determines how evenly and quickly Be sure to read and observe all the following points when heat is transferred from the surface element to the pan home canning with your appliance. Check with the USDA bottom.
Operating surface elements - Surface elements may appear to have cooled after they have been turned off. The element surface may still be hot and burns may occur if the element or the area surrounding the element is touched before it has cooled sufficiently.
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become familiar with the various pad features and functions of the oven as described below. Feature indicator Bake time pad-- Up and down arrow pads-- Use with the lights-- These to enter the length of...
Setting a silent control panel When choosing a function, a tone will be heard each time a keypad is pressed. If desired, the control can be programmed for silent operation. The indicator light located above the timer on=off pad will glow while the minute timer is active. To blockthe controls from sounding when any keypad is pressed in the future, press and hold start time keypad for...
Setting bake Setting bake time The oven can be programmed to bake at any temperature The bake time pad sets the amount of time needed for from 170°F to 550°F (77°C to 287°C). The factory preset baking. The oven will turn on immediately and stop automatic bake temperature is 350°F (177°C).
Setting bake time start time The bake time and start time pads may be used to set the length of baking time and to delay the starting time (delayed timed bake). The oven will turn on at a later time and stop automatically after the set bake time ends.
Setting broil Use the broil feature to cook meats that require direct exposure to radiant heat for optimum browning results. Insert When broiling always remember to arrange the oven racks while oven is still cool. Position the rack as suggested in the broil settings table (See Figs. 1 & 3). To set Broil Arrange the oven rack while oven is still cool.
Adjusting the oven temperature Setting oven lockout The control can be programmed to lock the oven door and Your appliance has been factory calibrated and tested to lockout the oven control pads. ensure an accurate baking temperature. For the first few uses, follow your recipe times and temperature To set the oven lockout feature...
Self=Cleaning A self-cleaning oven cleans itself with high temperatures During the self-cleaning cycle, the outside of the range (well above normal cooking temperatures) which eliminate can become very hot to the touch. DO NOT leave small soils completely or reduces them to a fine powdered ash children unattended near the appliance.
Page 18
Setting a self-clean cycle or a delayed start self-clean cycle When the self-clean cycle has completed: The time of day will appear in the display window and the "Clean" and "LOCK" light will continue to glow. Once the oven has cooled down for about 1 HOUR and To start a self-clean cycle immediately without a delay, the "LOCK"...
Cleaning recommendation table Surface type Recommendation - Control knobs For general cleaning, use hot, soapy water and a cloth. For more o Painted body parts difficult soils andbuilt-up grease, apply a liquid detergent directly onto Painted decorativetrim the soil. Leave on soil for 30 to 60 minutes. Rinse with a damp cloth - Aluminum, plasticorvinyl trim pieces...
Surface elements and drip bowls Cleaning drip bowls Wash in hot, soapy water or in the dishwasher. Rinse and dry while still warm. Hard to remove, burned on soil can be Make sure drip bowls are in place - Absence of removed by soaking the drip bowls for about 20 minutes in these bowls during cooking may subject wiring or a lightly diluted liquid cleanser or a solution of ammonia and...
Caution for aluminum use on the cooktop Aluminum Foil =Use of aluminum foil on a hot cooktop To replace the interior oven light bulb can damage the cooktop. Do not use thin aluminum 1. Turn electrical power off at the main source or unplug cooking utensils or allow aluminum foil to touch the the range.
Removing and replacing the lift-off oven door Oven door The door is heavy. For safe, temporary storage, lay the door hinge locations flat with the inside of the door facing down. with oven door fully open, To remove oven door: Open oven door completely (horizontal with floor- See Fig.
...._ ..... Problem Solution Poor baking results, - Many factors affect baking results. Hake sure the proper oven rack position is used. Center food in the oven and space pans to allow air to circulate, Allow the oven to preheat to the set temperature before placing food in the oven.
Page 24
Problem Solution Soil not completely removed after self- o Failure to clean bottom, front top of oven, frame of oven or door area cleaning cycle, outside oven seal. These areas are not in the self-cleaning area, but get hot enough to burn on residue. Clean these areas before the self-cleaning cycle is started.
Yourapplianceis coveredby a oneyear limitedwarranty.Foroneyearfromyour originaldateof purchase, E lectrolux will payall costsfor repairingor replacinganypartsof this appliancethat prove to bedefectivein materialsor workmanship whensuchapplianceis installed,usedandmaintained in accordance w ith the providedinstructions. Exclusions This warranty does not cover the following: Products with original serial numbers that have been removed, altered or cannotbe readily determined. Product that has been transferred from its original owner to another party or removed outside the USAor Canada.