Miele DA 428-4 Operating And Installation Manual
Cooker
Hide thumbs
Also See for DA 428-4:
- Operating and installation manual (40 pages) ,
- Operating and installation instructions (40 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Miele DA 428-4
Summary of Contents for Miele DA 428-4
- Page 1 Operating and installation instructions Cooker hood DA 428-4, DA 428-4 EXT DA 429-4, DA 429-4 EXT en - GB To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Miele|home ........ -
Page 3: Caring For The Environment
Caring for the environment Disposal of the packing material Disposal of your old appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and should be recycled. -
Page 4: Warning And Safety Instructions
Any other usage is not supported by requirements. Inappropriate use the manufacturer and could be can, however, lead to personal injury dangerous. Miele cannot be held liable and damage to property. for damage resulting from incorrect or improper use or operation. -
Page 5: Technical Safety
Faulty components must only be the appliance could be damaged. replaced by genuine Miele original Consult a qualified electrician if in any parts. The manufacturer can only doubt. guarantee the safety of the appliance... - Page 6 These models may only be combined with a Miele external motor. This appliance must not be used in a non-stationary location (e.g. on a ship). Great care should be taken when...
- Page 7 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heating appliance are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
-
Page 8: Correct Use
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé... -
Page 9: Correct Installation
Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use. -
Page 10: Guide To The Appliance
Guide to the appliance... -
Page 11: Guide To The Appliance
Guide to the appliance Telescopic extension piece Touch control for grease filters Tower The indicator lamp for the grease filters lights up when the grease filters need Canopy to be cleaned. Control panel The touch control is used to reset the Grease filters operating hours counter every time the grease filters are cleaned (see... -
Page 12: Modes Of Operation
Modes of operation . . . air recirculation: The cooker hood works with (this requires an optional conversion kit and charcoal filter: see "Technical Data") . . . air extraction: The air is drawn in and cleaned by the The air is drawn in and cleaned first by grease filters and directed outside. -
Page 13: Miele|Home
Miele electric of the cooker hood. hob with onset controls. This module must be installed by a... -
Page 14: Operation
Operation To switch the fan on Automatic switch-off of the Intensive setting You can set the Intensive setting so that it only runs for 10 minutes before reverting automatically to level III. ^ Press the On/Off touch control. ^ To set this option, both the fan and The fan runs at power level "II". -
Page 15: Run-On Option
Operation Run-on option It is advisable to run the fan for a few minutes after cooking has finished to neutralise any lingering odours in the The indicator lamps for fan power levels air, whether you are using air extraction I and IV will flash if the automatic or recirculation mode. -
Page 16: To Switch The Hob Lighting On
Operation To switch the hob lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting control to switch on the hob lighting. - Page 17 Operation Reading the operating hours counter Altering the operating hours counter for the grease filters for the grease filters To check the percentage of time set The operating hours counter for the already used: grease filters is set at 30 hours. This can be lengthened or shortened to suit the type of cooking you do.
- Page 18 Operation Activating and altering the operating hours counter for the charcoal filter (in recirculation mode) The charcoal filter is needed for The – / + control lamps show the time recirculation mode. which has been set: 1st lamp from the left = 20 hours On delivery, the operating hours counter 2nd lamp from the left = 30 hours for the charcoal filter is switched off,...
- Page 19 Operation ^ Use the – / + controls to select the Reading the operating hours counter desired time. for the charcoal filter To check the percentage of time set already used: ^ Confirm the selection by pressing the charcoal filter touch control. All the indicator lamps will go out.
-
Page 20: Cleaning And Care
Cleaning and care A range of Miele branded cleaning and Do not use too much water when conditioning agents are available to cleaning the controls. Water could order through your Miele Dealer / Chartered Agent, the Miele Spare Parts penetrate into the electronics and Department, or via the internet on cause damage. -
Page 21: Grease Filters
Cleaning and care Grease filters Important for appliances with special finish The re-usable metal grease filters in the (Titanium and special order finishes) appliance remove solid particles (grease, dust, etc.) from the kitchen Please follow the information given in vapours, preventing soiling of the “General notes"... - Page 22 ^ After replacing the grease filters, ^ Do not wash at more than 65° C. If a press the grease filter touch control Miele dishwasher is being used, for approximately 3 seconds to re-set select the Sensor wash programme. the operating hours counter.
-
Page 23: Fitting And Replacing The Charcoal Filter
New filters can be purchased from – if it is no longer effective in absorbing your Miele Dealer / Chartered Agent kitchen odours. or from the Miele Spare Parts It should, however, be replaced at least Department. -
Page 24: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Exercise caution when changing halogen lamps. They get very hot during use and remain hot for some time after being switched off. Let them cool down before you change them. -
Page 25: After Sales Service
For information on the appliance under guarantee, please contact: guarantee specific to your country – Your Miele Dealer / Chartered Agent please contact Miele. See back cover for contact details. In the U.K. your appliance is –... -
Page 26: Appliance Dimensions
EXT models for feeding the connection cable through to the external motor. For recirculation mode, only a connection socket needs to be fitted. Connection for air extraction C 150 mm, or C 125 mm with reducing collar. DA 428-4 DA 429-4... -
Page 27: Safety Distance (S)
If this cooker hood is installed above when planning the installation height a Miele Wok CS 1028 CombiSet of the cooker hood. appliance, a minimum safety distance of 760 mm must be maintained between the burner and the lower edge of the cooker hood. -
Page 28: Installation
Installation Assembly parts... - Page 29 Installation 3 protective sheets for use when fitting the tower. 1 exhaust connection for exhaust 6 screws 5 x 40 mm and ducting C 150 mm. 6 x S 8 plugs 1 reducing collar for securing the wall bracket. for exhaust ducting C 125 mm. The screws and plugs are 1 non-return flap designed for use in solid walls only.
-
Page 30: Installation Instructions
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet. -
Page 31: Connection For Air Extraction
Connection for air extraction – Only use smooth pipes or flexible Important: To avoid the danger of hoses made from non-flammable toxic fumes, please observe the materials for the extraction ducting. Warning and Safety instructions. – When using an external motor, make This is especially crucial when using sure that the exhaust ducting is the cooker hood at the same time as... -
Page 32: Condensate Trap
Connection for air extraction Condensate trap – If the exhaust air is to be ducted into the open air, the installation of a (optional accessory) telescopic wall vent or roof vent (available as an optional accessory) is recommended. – If the exhaust air is to be ducted into a vent flue, the ducting must be directed in the flow direction of the flue. -
Page 33: Silencer
Connection for air extraction Silencer ...with air extraction: (optional accessory) The silencer not only reduces noise from the motor outside the house, but also sounds from outside (e.g. traffic noise). For this reason the silencer must be positioned as close as possible to the ducting exit ...in recirculation mode: The silencer needs to be positioned... -
Page 34: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual... -
Page 35: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 control module can Components used in the central be used to combine the cooker hood ducting system are not supplied by with other components. Miele. It enables the following: If in any doubt, the advice of a... -
Page 36: Technical Data
Total connected load* Fan performance* DA 428-4 ....240 W Extraction power according to DA 429-4 ....260 W EN 61591 Fan motor* . - Page 40 Alteration rights reserved / 3011 M.-Nr. 09 201 750 / 00...