Related Manuals for Miele Imperial DA 846-1
Summary of Contents for Miele Imperial DA 846-1
- Page 1 Operating and Installation Instructions ..........................Cooker Hood DA 846-1 (Vented)
-
Page 2: Table Of Contents
Contents ............2 . - Page 3 Caring for the environment The transport and protective packa- Old appliances contain materials which ging has been selected from materials can be reclaimed or recycled. Please which are environmentally friendly for contact your dealer, your waste collec- disposal and can normally be recycled. tion centre or scrap merchant about potential recycling schemes.
- Page 4 Guide to the appliance...
-
Page 5: Run-On Option
This control selects and de-selects "Automatic" operation in which drawing the vapour guide down or pushing it back up alters the fan power level. This indicator lamp for the grease filter touch control lights up when the grease filter needs to be cleaned. This is used to switch the lighting in the The touch control is used hood for illuminating the hob on and... - Page 6 Description of the functions The cooker hood works with The air is drawn in and cleaned by the grease filter and directed outside. The cooker hood is fitted with a This flap is closed when the cooker hood is switched off. No exchange of room air and outside air can take place.
- Page 7 Warning and Safety instructions national regulations. It is most import- This appliance meets statutory ant that this basic safety requirement is safety requirements. Inappropriate tested by a qualified electrician. use could however lead to risk of ac- The manufacturer cannot be held re- cidents to the user and damage to sponsible for the consequences of an the appliance.
- Page 8 These can be obtained from the Overheated oil and fat can ignite and Miele Spare Parts department or from could set the cooker hood on fire. builders’ merchants. Do not use the cooker hood with- The appliance must not be con- out the grease filters in place.
- Page 9 When using the cooker hood at the In countries which may be subject same time as another heating ap- to infestation by cockroaches or pliance which depends on the air in the other vermin, pay particular attention to room, (e.g. gas, oil or coal fired keeping the appliance and its surround- heaters, continuous flow or other water ings in a clean condition at all times.
- Page 10 Operation When the vapour guide is completely Depending on how much the air needs retracted, the electrical connection is to be filtered, there are four power le- switched off. In this position the cooker vels available. For normal cooking a hood cannot be operated.
- Page 11 With automatic operation the power set- ting can also be altered manually. You can switch the fan off by either Use the power level control to select repeatedly pressing the left hand the setting required. side of the power control until all the indicator lamps go out, Whatever the position of the vapour guide the fan will switch to the power...
-
Page 12: Power Cut
To check the percentage of time set al- ready used: Switch the fan on. The operating hours counter for the grease filter is set at the factory for 30 hours. (This can be changed if re- quired. See “Altering the grease filter operating hours”). - Page 13 You can set the operating hours Press the run-on and grease filter counter to suit the type of cooking you touch controls at the same time. The indicator lamp for the grease filter – Select a short time if you roast or fry touch control and one of the control a lot.
- Page 14 If there is a power cut while the vapour guide is pulled down, the Automatic function is cancelled. Restore as follows: Push the vapour guide right back in (until a resistance is felt). Draw the vapour guide back down again until the desired power level position is reached.
- Page 15 Cleaning and care Before any cleaning or maintenance work the cooker hood must be iso- lated from the power supply at the mains fuse box or the wall connec- tion unit (as appropiate). See "Warn- ing and Safety" instructions. Ensure current is not supplied to the appliance while maintenance or re- pair work is being carried out.
- Page 16 Clean the filters – with a scrubbing brush in a mild solution of warm water and washing up liquid. – place the filter with the short side upright in the lower basket, ensuring the spray arm is not obstructed. Depending on the cleaning agent used, cleaning the grease filters in a dishwasher can cause permanent discolouration of the surface of the...
- Page 17 Isolate the cooker hood from the power supply at the mains fuse box or the wall connection unit (as ap- propriate). See "Warning and Safety" instructions. Unscrew and remove the securing screw on the lamp cover. Take the lamp cover off downwards at an angle.
-
Page 18: Housing
In the event of any faults which you can- not remedy yourself, please contact: – Your dealer – The Miele Service Dept., (see ad- dress on back page). When contacting the Service Depart- ment, please quote the Model and Ser-... - Page 19 Electrical connection The wires in the mains lead are col- All electrical work should only be car- oured in accordance with the following ried out by a suitably qualified and com- code: petent person in accordance with na- Green/yellow = earth tional and local safety regulations.
- Page 20 If this machine or appliance is fitted with a non-rewireable plug, the follow- ing information applies: If the socket outlets are not suitable for the plug supplied with this product, it must be cut off and an appropriate plug fitted. The fuse carrier and the fuse should be removed from the old plug and disposed of.
- Page 21 Installation The cooker can only be installed above an electric hob. Safety regulations prohibit the fitting of this cooker hood over a gas hob, an open grill (electric) or a solid fuel stove. The distance between the top of the hob and the bottom of the cooker hood (when the vapour guide is completely retracted) must measure...
- Page 22 The cooker hood must only be lifted by the main body, and not by the va- Take off the door of the wall unit for pour guide. easier installation. Fix the support tracks on each interior Push the cooker hood into the wall side wall of the unit, using four 3.5 x unit from the front and hang on the 16 mm screws for each track.
- Page 23 19 mm thick unit sides: Use 3.5 x 16 mm screws to secure the cooker hood to the wall unit on both sides at the lower edge of the 16 mm thick unit sides: body. Screw the cooker hood securely to the wall unit to the support tracks on each side with the 3.5 x 16 mm screws.
- Page 24 Units deeper than 285 mm require the fitting of a spacer bar to prevent va- pours collecting between the rear of the cooker hood and the wall. Press the facia strips into their holders according to the thickness of the side walls. Observe the markings Shorten the spacer bar to the appro- on the rear of the facia strips.
-
Page 25: Connection For Extraction
Fit each grease filter with the hand hold to the rear. For exhaust connection, push the ducting on to the vent socket of the Fit the door back on to the wall unit. cooker hood Complete venting installation (see section "Connection for extraction"). Push the shelf, with the punched edge pointing upwards between the guide lugs. - Page 26 Installation - extraction – When ducting is horizontal it must be laid to slope away at 1 cm per metre, to ensure no condensate drains into Danger of toxic fumes. the appliance. Please heed the “Warning and Safety instructions” to avoid the danger of toxic fumes.
-
Page 27: Condensate Trap
If the exhaust ducting is to run through rooms, ceiling space etc., where there may be great variations in temperature between the different areas, the prob- lem of sweating or condensation will need to be addressed. The exhaust ducting will need to be suitably insulated. - Page 28 Technical data Rated load ....212 W Motor ..... 190 W Lighting .