Related Manuals for Haier LE55H330
Summary of Contents for Haier LE55H330
- Page 1 OWNER’S MANUAL LE55H330 LED-LCD TELEVISION Please READ this manual carefully before operating your TV, and retain it for future reference.
-
Page 2: Table Of Contents
Contents Contents Function Menu ...........18 Warning Function Menu Set ............18 Adjust Menu ............19 Important Safety Instructions Time Menu ............19 Introduction Lock Setup ............20 Panel Control ............6 How to use the password function ......20 Connection Option ..........7 Advanced function To watch a 3D TV ..........21 Remote Control... -
Page 3: Warning
Warning Warning WARNING RISK ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL. * To avoid electric hazards, it is strongly suggested that the back cover not be opened, as there is no any accessory inside the casing. -
Page 4: Important Safety Instructions
Important Safety Instructions Important Safety Instructions LED -LCD television Owner’s Manual... - Page 5 Important Safety Instructions LED -LCD television Owner’s Manual...
-
Page 6: Introduction
Panel Control and Rear Terminals Control Introduction - This is a simplified representation of front panel. - Here shown may be somewhat different from your TV. Panel Control Press this key to open/close signal source 1 SOURCE options menu. Menu display. Press to access the on-screen 2 MENU menu display. -
Page 7: Connection Option
Remote Control Connection Options Back panel connections Connect a video cable from a computer to this Connect cable pr antenna signal to the TV, either 8 ANT In PC Video In jack.. directly or through your cable box. PC/DVI Audio Connect the audio L/R cables from a computer Digital Audio Optical output. -
Page 8: Remote Control
Panel Control and Rear Terminals Control Remote Control Battery loading 1. Slide open the cover of the battery compartment on the back of the remote controller. 2. Load two 7# (AAA) alkaline batteries in the compartment, (plus and minus poles to respective mark) 3. -
Page 9: Remote Control Function
External Equipment Connections Remote Control Function - The remote control cannot be operated unless the batteries are properly loaded. - When using the remote control, aim it at the remote control sensor on the TV. Function introduction Press this key to start TV from standby mode, press it again to return to standby 1 POWER mode. -
Page 10: External Equipment Connections
Remote Control Function External Equipment Connections Antenna Connection - Antenna or Cable Service without a Cable Box Connections. - For optimum picture quality, adjust antenna direction if needed. Note: * It is recommended that you'd better use 75 coaxial cable to remove the disturbance caused by airwave. -
Page 11: Choose Your Connection
External Equipment Connections select the source, press the OK button to confirm. Choose Your Connection There are several ways to connect your television, External AV Source Setup depending on the components you want to connect and the quality of the signal you want to achieve. The following are examples of someways to connect How to connect your TV. -
Page 12: Hdmi Or Dvi Setup
External Equipment Connections How to use Turn on the DVD player, insert a DVD. PC Setup Use the SOURCE button on the remote control,and then press button to to select COMPONENT How to connect mode, press the OK button to confirm. Press Play button on external equipment for Use the TV’s PC IN port for video connections. -
Page 13: Monitor Out Setup
External Equipment Connections / Basic Receiving and Playing Operations External Equipment Connections Note ❏ Component, PC, HDMI input sources cannot be used for Monitor out. ❏ When connecting with external audio equipments, such as amplifiers or speakers, please turn the TV speakers off. -
Page 14: Basic Receiving And Playing Operations
Troubleshing and Specification Basic Receiving and Choose the Input source Change the picture source so you can watch your TV, Playing Operations VCR, Cable , or any other devices that are connected to Playing Operations your TV. Press SOURCE button to enter the Input Source Switching ON/OFF the TV set menu and then use button to select the... -
Page 15: How To Customize Your Own Picture Status
Specification and Format color, afterwards press to adjust; if a different benchmark is selected for adjustment, the original Back light adjustment data will be automatically cleared. Four_DIM Back light Reset Contrast Brightness Color Sharpness Tint Palette Four_DIM Picture Prog... DTV Manu. Cool2 Sound Volume... -
Page 16: Channel Menu
Troubleshing and Specification Press button to select the desired items, Reset press OK to enter its submenu. Return to factory default settings. Press button to adjust the setting. Channel menu Volume Press to adjust the volume of TV set. Display channel menu by pressing SOURCE button then button to select the source of ATV or DTV Balance item. -
Page 17: Auto Tuning
Specification and Format Press button to select Auto Tuning, then Back light LED Four... press OK to enter its submenu. Intelligent Mode Upgrade fine tuning function is for the purpose of improving picture effect through fine tuning when that of a certain program is not good enough. -
Page 18: Function Menu
Troubleshing and Specification After adjusting the current channel and the found to then press to select ON or OFF. be exchanged to, press to move the cursor • Press to select the DNR to be adjusted, and to the Exchange option, and then press OK to start then press to select Low/Middle/High/ Off. -
Page 19: Adjust Menu
Specification and Format This is used for adjusting the phase of pixel clock in PC Back light LED Four... Contrast Brightness Color Sharpness Tint Reset Picture Palette mode. Eye Guard Mode Sound Volume Balance Digital MAXX Bass Reset Phase PowerOn E.G.Mode <... -
Page 20: Lock Setup
Troubleshing and Specification the On/Off Time function is enabled while OFF automatically disappear. indicates the function is disabled. The Lock Set menu is as follows: • After finishing time setting, press OK or MENU to confirm. Lock Set Note Change Password After setting the On/Off Time function, if the TV is AC Tuning Lock off or forcible DC off, the function will be automatically... -
Page 21: Advanced Function
Specification and Format OFF, the preset function will be closed. Preset Prog Advanced function Only when the Preset Source is set as TV can the Preset Channel option be available. Press To watch a 3D TV select preset channels from 0-255. Source Lock This function is used to prohibit watching a program from various external inputs, e.g. -
Page 22: Streaming Media Playing System
Troubleshing and Specification Streaming Media Playing System Note ❏ The diagrams in the following section are schematic and only for your reference. Please see Press to select the “Confirm” option, you will the actual product if necessary. enter the interface for selecting a corresponding 3D mode. -
Page 23: Start/Exit Streaming Media Playing System
Specification and Format Press to scroll through main menu or • The file code rate should be lower than 300KB/S; • Due to the limitation of USB signal transmission submenu and select your desired option. distance, it is recommended not to use USB patch Press OK to confirm your selection. -
Page 24: Playing A Movie
Troubleshing and Specification Playing Music After entering USB main interface, press select a harddisk partition, and then press select the Music option. PLAY/PAUSE Press OK to confirm the selection and press play the music of your choice. To exit playing, just press BACK repeatedly. PLAY/PAUSE Press to control the music... -
Page 25: Settings
Specification and Format Wired network connection To exit the Text mode, just press BACK repeatedly. Settings After entering USB main interface, press select the Settings option. Press OK to confirm the selection and enter the settings selection interface, and then press to select the required options. -
Page 26: Network Settings
Troubleshing and Specification work due to the driver compatibility. After the settings have been completed, Press the "Confirm" to confirm or move to the "Confirm” and press it to confirm. Set up the wireless router If you want to use wireless network card, firstly you must have a wireless router;... -
Page 27: Dial-Up Setting
External Equipment Connections Maintenance / Troubleshooting/Specification The types are as follows: D-Link DWA-130, Netcore browse. NW336, Cameo WLN-1508. Please correctly set the wireless router. Refer to wireless router settings on Page 25 for the details. Setting other features Plug in the wireless network card and enter into the "wireless settings"... -
Page 28: Fast Downloading/Network Downloading
Remote Control Function main menu, can be viewed or operated. popularity; • Download Rank/Download Top 10: According to ❏ 11 items set in U Channel of this TV set as follows, download popularity; are available for you to select part or all of them in •... -
Page 29: Online Movies/Stock
External Equipment Connections compression and update of the online theatre Stock resources.; • To ensure a smooth network function, it is recommended that your network bandwidth is no less than 2M. Lag phenomenon may occur when Press to enter the streaming media operating playing soon, which is normal because the system system . -
Page 30: Education/Magazine/News
Remote Control Function Press to select the option. Press News enter in. Press to select the Video you Press to enter the streaming media operating want, and then press to watch; if you want to system . Press click the " News" item (must stop, please press the "BACK"... -
Page 31: Music/Weather/Intelligent Interaction
External Equipment Connections Red button: Ordering ring tones; Green button: Can share with friends; Yellow button: Network with the singing; Blue button: Add to favorites. Weather Press to enter the streaming media operating Intelligent Interaction system . Press click the "Weather" item (must be loaded through the U channel function)and click •... -
Page 32: Maintenance
Remote Control Function Specification / Format Inbox Maintenance After entering the “Intelligent Interaction” interface, you can see what is shared from your friend(s) in the Maintenance “inbox”, if any. For pictures or audio content, you can enjoy directly; but video download link(s), you have to Early malfunctions can be prevented. -
Page 33: Specification
External Equipment Connections sound might be produced. These phenomena Turn onthe power supply; Properly might happen in the area 1,500 meters above the plug theTV setto the powersocket; sea level. This is resulted from difference between Check to see if the power cable of other picture, air pressures inside and outside the display. -
Page 34: Format
Remote Control Function approximation. 720p 50/60 Format 1080i/1080p 50/60 Recommendatory HDTV/ SDTV(YP b P r /YC b C r ) format Sequence Refresh Format Number Frequency (Hz) 480i/480p 576i/576p 720p 50/60 1080i/1080p 50/60 Recommendation PC connection input format sequence H-Frequency V-Frequency Format number... - Page 35 External Equipment Connections LED -LCD television Owner’s Manual...