HP Deskjet 1280 User Manual

Ciss - continuous ink system

Hide thumbs Also See for Deskjet 1280:

Download this manual

Thanks for your purchasing our continuous ink system for HP Deskjet 1280. Our continuous ink system is

the idea set for inkjet printer which can low down the printing cost. Before your using of CISS, pls kindly

read the instruction with details. In this way, you can install this system without troubles then.

1.General Guide

1)components

A. CIS system 1 set

D.Refill kit 4pcs

2) Opening box for inspection

a. Check whether all the accessories are ready

b. Check whether there is leakage of CIS system, whether the tubes has been separated from CISS.

2.Printer testing

Check whether the printer is in normal condition, such as mechanical status, lubrication

status etc. After installation of this system, it will not low down the printing precision,

so you have no need to worry about that.

3. Installation procedure:

1) first step

Put the CISS on the right side of the

printer,In the mean time, place all the

tubes at correct position ( make sure the

printer and ink tank should be in one level)

2) Set up the CISS system

Open the printer power

CISS for HP Deskjet 1280

B. Air filter

4pcs

E. Instruction CD 1pc

Open the air hole

Open the cover for the printer

C. support arm

2 sets

F. pedestal for drawing air 1set

Place the air filter into the air hole,

make sure that the thicker side is down

the tank

Ink vehicle out

Page 1 Thanks for your purchasing our continuous ink system for HP Deskjet 1280. Our continuous ink system is the idea set for inkjet printer which can low down the printing cost. Before your using of CISS, pls kindly read the instruction with details. In this way, you can install this system without troubles then.
Page 2 Open the cover of the ink vehicle Put out the original cartridges 3. Installation of the support arm We have installed the support arm in the cartridges Close the tubes to the support arm by clasp, and make sure the tubes are not contorted 4、Adjust he tubes Pull out the power wire, then move the Ink vehicle...
Page 3 And after several times of cleaning, there is still some uncontinuous condition, especially for the single color, you can keep the printer for about one hour, the printer will be ok then.If after testing, still unnormal, you can...
Page 4 5. Do not Place the reservoir higher or lower thantherprinter 6. Some color of the printer will leak out for long time no work. If using that printer, will cause some problems then, so before using, pls check whether there is ink in the cartridges, if no, do not open the printer, and send it to be repaired.