Table of Contents
Advertisement
Quick Links
Installation
Instructions
If you have questions, call 1.800.561.3344 or visit our website at:
www.geappliances.ca
Before You Begin
Read these instructions carefully and completely.
IMPORTANT
•
instructions for local inspector's use.
IMPORTANT
•
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
Parts Included
(Appearance will vary.)
Screws for Installation
(8-18 x .750 flat head
Phillips wood screws)
WB07T10578 – Black
WB07T10579 – SS
Optional 68.6 cm (27")
Metal Bottom Trim Assembly
(on some models or can be
purchased separately)
31-10666-3
11-07 JR
—Save these
—Observe all
68.6 cm (27")
Metal Bottom Trim
76.2 cm (30")
Metal Bottom Trim
Assembly
Built-In Wall Oven
27" (68.6 cm) models
JCKS10, JCKP30, JCKP70, PCK916, PCK920
30" (76.2 cm) models
JCTP30, JCTP70, PCT916, PCT920
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
• NOTE—This appliance must be properly
grounded.
ATTENTION INSTALLER
•
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Materials Needed
Strain Relief Clamp
for 1/2" conduit
Tools Needed
1/8" (3 mm) Drill Bit and
Electric or Hand Drill
1
Wire Nuts
Junction
Box
91 cm (36") of String
Phillips
Screwdriver
Advertisement
Table of Contents
Related Manuals for GE JCKS10
Summary of Contents for GE JCKS10
-
Page 1: Installation Instructions
Built-In Wall Oven Installation 27” (68.6 cm) models JCKS10, JCKP30, JCKP70, PCK916, PCK920 Instructions 30” (76.2 cm) models JCTP30, JCTP70, PCT916, PCT920 If you have questions, call 1.800.561.3344 or visit our website at: www.geappliances.ca Before You Begin • Proper installation is the responsibility... -
Page 2: Important Safety Instructions
Installation Instructions IMPORTANT SAFETY INSTRUCTIONS For Your Safety Electrical Requirements • Be sure your oven is installed properly by (cont.) a qualified installer or service technician. Rating Plate is located on oven side trim, • Be sure the oven is securely installed in a side front frame or lower front frame. - Page 3 Installation Instructions Pre-Installation Checklist Remove packaging materials. Check Door removal is not a requirement for behind hinges and under false bottom. installation of the product, but is an Remove labels on the outside of the added convenience. To remove the door: door, plastic on trims and panel, all Open the oven door as far as it will go.
- Page 4 Installation Instructions Cutout for 27″ Single Built-In (68.6 cm) Ovens only For JCKP30, JCKP70, JCKS10, PCK916, PCK920 models only. 12.7 cm Cabinet Width 68.6 cm (27”) (5”) Max. from the left or right Cabinet Recommended side Width Junction Box Cutout Location 68.6 cm...
- Page 5 Installation Instructions Cutout for 30″ Single Built-In (76.2 cm) Ovens only For JCTP30, JCTP70, PCT916, PCT920 models only. Cutout Width Cabinet Width 76.2 cm (30”) 24.1 cm 72.4 cm (9 1/2”) (28 1/2”) Min. Recommended Max. 72.7 cm Cutout Location (28 5/8”) Max.
- Page 6 Installation Instructions Cutout for 27″ Single Built-In Ovens only (68.6 cm) Under Counter For JCKP30, JCKP70, JCKS10, PCK916, PCK920 models only. Electric cooktops may be installed over this oven. See cooktop installation instructions for cutout size. See label on top of oven for approved cooktop models.
- Page 7 Installation Instructions Cutout for 30″ Single Built-In Ovens only (76.2 cm) Under Counter For JCTP30, JCTP70, PCT916, PCT920 models only. Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for cutout 240V / 208V size. See label on top of oven for approved cooktop Junction Box models.
- Page 8 Installation Instructions Cutout for 30″ Single Built-In (76.2 cm) Ovens only – Over a Warming Drawer For JCTP30, JCTP70, PCT916, PCT920 models only. Anti-Tip Block Against Rear Wall Per Warming Drawer Requirement 2” (5.1 cm) Min. Per Warming Drawer Requirement NOTE: Install the oven only with specific models...
-
Page 9: Attention Installer
Installation Instructions Electrical Connections Turn off the circuit breaker or remove fuses ATTENTION INSTALLER to the oven branch circuit. All electric wall ovens must be hard wired With the oven supported on a table or (direct wired) into an approved junction platform in front of the cabinet opening, box. -
Page 10: Securing The Oven In The Opening
Installation Instructions Securing the Oven in the Opening Sliding the Oven Into the Drilling the Pilot Holes and Opening Mounting the Oven a. Loop (do not tie) a 91 cm (36”) string around the conduit before the oven is slid NOTE: Before drilling the pilot holes, into place. - Page 11 Installation Instructions Installing the Metal Preparing for the Bottom Bottom Trim Trim Installation a. Place the bottom metal trim centered over a. With oven installed, take the bottom trim the pre-drilled mounting holes. Tape the and center it on the bottom front edge of edges of the trim down to maintain the the cabinet opening.
-
Page 12: Replacing The Oven Door
Installation Instructions Replacing the Oven Door Open the oven door as far as it NOTE: The oven door is heavy. You will open. may need help lifting the door high enough to slide it into the hinge slots. Push the hinge locks up against the Do not lift the door by the handle. -
Page 13: Operation Checklist
Installation Instructions Pre-Test Checklist Remove all protective film, if present, Check that the bottom trim is installed and any stickers. properly (see page 10). Check to be sure that all wiring is Check to be sure the mounting screws secure and not pinched or in contact are installed and flush with the side trim with moving parts. - Page 14 Notes...