Table of Contents
Advertisement
3-2.
ADJUSTMENT REMOTE COMMANDER
(NEW LANC JIG)
The adjustment remote commander (New LANC Jig) is used for
changing the calculation coefficient in signal processing, EVR data,
etc. The adjustment remote commander (New LANC Jig) performs
bi-directional communication with the unit using the remote com-
mander signal line (LANC). The resultant data of this bi-direc-
tional communication is written in the non-volatile memory.
1. Using the Adjustment Remote Commander
(New LANC Jig))
1) Connect the adjustment remote commander (New LANC Jig)
to the LANC terminal via the LANC cable (J-6082-442-A).
2) Set the slide switch of the adjustment remote commander (New
LANC Jig) to "SERVICE" (SERVICE position). If it has been
properly connected, the LCD on the adjustment remote com-
mander (New LANC Jig) will display as shown in Fig. 6-3-2.
p:00 a:00 d:00
Page
3) Operate the adjustment remote commander (New LANC Jig)
as follows.
• Changing the page
The page increases when the Page+ (M) button is pressed,
and decreases when the Page− (m) button is pressed.
• Changing the address
The address increases when the ADD+ (N) button is
pressed, and decreases when the ADD− (X) button is
pressed. There are altogether 256 addresses, from 00 to FF.
• Changing the data (Data setting)
The data increases when the Data+ button is pressed, and
decreases when the Data− button is pressed. There are alto-
gether 256 data, from 00 to FF.
• Writing the adjustment data
The Write (x) button must be pressed to write the adjust-
ment data in the nonvolatile memory. (The new adjusting
data will not be recorded in the nonvolatile memory if this
step is not performed)
4) After completing all adjustments, turn off the main power sup-
ply once.
HVR-M15J/M15U/M15N/M15E/M15P/M15C
Address
Data
Fig. 6-3-2
2. Precautions Upon Using
the Adjustment Remote Commander (New LANC Jig)
Mishandling of the adjustment remote commander (New LANC
Jig) may erase the correct adjustment data at times. To prevent
this, it is recommended that all adjustment data be noted down
before beginning adjustments and new adjustment data after each
adjustment.
6-61
- Quick Links:
- Self-Diagnosis Function
- Cassette Tapes
Hide quick links:
Advertisement
Table of Contents
