Table of Contents
Advertisement
HOW TO INSTALL REFRIGERATOR
3. How to Control the Amount of Water Supplied to Icemaker.
3-1. Confirm the amount of water supplied to the icemaker.
1. Remove the cover bucket : Lift the cover with a slight twisting.
2. Remove the ice bucket : Lift the lower part slightly and take the ice bucket out slowly.
3. Apply electricity after connecting water pipe.
1) Press test switch under the icemaker for two seconds as shown below.
2) The bell rings(ding~dong) and ice tray rotates and water comes out from the icemaker water tube.
3) The water shall be supplied two or three times into the tray. The amount of water supplied for each time is small.
Put a water container under the ice tray and press test switch.
4) When ice tray rotates, the water in it will spill. Collect the spilt water and throw away into the sink.
5) When ice tray has finished rotation, water comes out from the water tube. Confirm the amounts of water in the ice tray.
(refer to fig. The optimum amount of water is 80cc)
Confirm the amount
of water(Recommend:
the water should
not be over this
maximum level line).
* It is acceptable if the adjusted level of water is a bit smaller than maximum level.
• Caution : • Do not put your hands or tools into the
chute to confirm the operation of geared
motor. It may damage refrigerator or hurt
your hands.
• Check the operation of motor with its operation
noise.
Test Switch
- 15 -
Ice maker
Hide quick links:
Advertisement
Table of Contents
