Information You Will Need From Your Adsl Service Provider - D-Link DSL-G624T User Manual
Wireless adsl router
Hide thumbs
Also See for DSL-G624T:
- User manual (111 pages) ,
- Quick installation manual (72 pages) ,
- Important manual (4 pages)
Table of Contents
Advertisement
Information you will need from your ADSL service provider:
Username
Password
WAN Setting /
Connection Type
VPI
VCI
The Setup Wizard can be used to configure the Internet connection for most users.
Note
DSL-G624T Wireless ADSL Router User Guide
This is the Username used to log on to your ADSL service
provider's network. It is commonly in the form −
user@isp.co.uk Your ADSL service provider uses this to
identify your account.
This is the Password used, in conjunction with the
Username above, to log on to your ADSL service provider's
network. This is used to verify the identity of your account.
These settings describe the method your ADSL service
provider uses to transport data between the Internet and
your computer. Most users will use the default settings. You
may need to specify one of the following WAN Setting and
Connection Type configurations (Connection Type settings
listed in parenthesis):
PPPoE/PPoA (PPPoE LLC, PPPoA LLC or PPPoA VC-Mux)
Bridge Mode (1483 Bridged IP LLC or
1483 Bridged IP VC-Mux)
Static IP Address (Bridged IP LLC, 1483 Bridged IP VC-Mux,
1483 Routed IP LLC, 1483 Routed IP VC-Mux or IPoA)
Dynamic IP Address (1483 Bridged IP LLC or
1483 Bridged IP VC-Mux)
Default = PPPoE/PPPoA (PPPoE LLC)
Most users will not be required to change this setting. The
Virtual Path Identifier (VPI) is used in conjunction with the
Virtual Channel Identifier (VCI) to identify the data path
between your ADSL service provider's network and your
computer. If you are setting up the Router for multiple
virtual connections, you will need to configure the VPI and
VCI as instructed by your ADSL service provider for the
additional connections. This setting can be changed in the
WAN Settings window of the web management interface.
Default value = 8
Most users will not be required to change this setting. The
Virtual Channel Identifier (VCI) used in conjunction with the
VPI to identify the data path between your ADSL service
provider's network and your computer. If you are setting
up the Router for multiple virtual connections, you will need
to configure the VPI and VCI as instructed by your ADSL
service provider for the additional connections. This setting
can be changed in the WAN Settings window of the web
management interface. Default value = 35
vii
Record info here
Advertisement
Table of Contents
