Dell PowerConnect B-DCX-4S Backbone Replacement Procedure
Power supply and filler
panel
Hide thumbs
Also See for PowerConnect B-DCX-4S Backbone:
- Hardware reference manual (134 pages) ,
- Replacement procedure (16 pages)
Related Manuals for Dell PowerConnect B-DCX-4S Backbone
Summary of Contents for Dell PowerConnect B-DCX-4S Backbone
- Page 1 53-1001794-01 January 31, 2010 Power Supply and Filler Panel Replacement Procedure Supporting PowerConnect B-DCX-4S Backbone and PowerConnect B-DCX Backbone 53-1001794-01 *53-1001794-01*...
- Page 2 Trademarks used in this text: Dell, the DELL logo, Inspiron, Dell Precision, Dimension, OptiPlex, Latitude, PowerEdge, PowerVault, PowerApp, Dell OpenManage and the YOURS IS HERE logo are trademarks of Dell Inc.; Intel, Pentium, and Celeron are registered trademarks of Intel Corporation in the U.S.
-
Page 3: In This Guide
In this guide • Power supply installation ......... 3 •... -
Page 4: Removing A Power Supply
Figure 2 shows the location and identification of the power supplies for the PowerConnect B-DCX-4S. Power supply 1 (PS1) Power supply 2 (PS2)) FIGURE 2 Power supply identification for the PowerConnect B-DCX-4S Removing a power supply 1. Perform one of the two following tasks: For the PowerConnect B-DCX: •... - Page 5 5. Grasp the handle and pull, sliding the power supply from the chassis and supporting the power supply from beneath as you remove it (Figure 3 Figure 6. If you are not replacing the power supply, insert a filler panel into the slot. FIGURE 3 Power supply for the PowerConnect B-DCX FIGURE 4...
-
Page 6: Replacing A Power Supply
Replacing a power supply 1. Remove any filler panel. 2. Insert the power supply into the slot and push the handle up. Verify that the power supply is seated by gently pulling on the handle. 3. Tighten the thumb screw. 4.