Miele DA 5100 D Operating And Installation Instructions
Miele ventilation system operating and installation instructions
Hide thumbs
Also See for DA 5100 D:
- Operating and installation instructions (40 pages) ,
- Installation instructions manual (15 pages) ,
- Installation instructions (1 page)
Related Manuals for Miele DA 5100 D
Summary of Contents for Miele DA 5100 D
- Page 1 Operating and Installation Instructions Ventilation System DA 5100 D en - US, CA To prevent accidents and machine damage, read these instructions before installation or use. M.-Nr. 06 878 360...
-
Page 2: Table Of Contents
Contents IMPORTANT SAFETY INSTRUCTIONS....... . . 3 Functional description ..........7 Guide to the hood . -
Page 3: Important Safety Instructions
Read these Operating Instructions carefully before installing or using the Ventilation System. This appliance is intended for residential use only. Use the appliance only for its intended purpose. The manufacturer cannot be held responsible for damages caused by improper use of the hood. - Page 4 However, under certain conditions it may be possible for installation in these applications. Please contact the nearest Miele dealer or the Technical Service Department with specific requirements. Before servicing or cleaning the unit,...
- Page 5 , WARNING - TO REDUCE THE RISK OF A COOKTOP GREASE FIRE: Never leave surface units unattended at high settings. Boil-overs cause smoking and greasy spillovers may ignite. Heat oils slowly on low or medium settings. Always turn the hood on when cooking at a high heat.
- Page 6 IMPORTANT SAFETY INSTRUCTIONS Installation , WARNING To reduce the risk of fire only use metal ductwork. Provided a larger distance is not given by the manufacturer of the cooktop, follow the minimum safety distances between a cooktop and the bottom of the hood: –...
-
Page 7: Functional Description
Functional description The ventilation hood works by air extraction. The air is drawn in and cleaned by the grease filter and directed outside. The hood comes equipped with a non-return flap. This flap automatically closes when the hood is turned off so that no exchange of outside air and room air can occur. -
Page 8: Guide To The Hood
Guide to the hood... -
Page 9: Control Panel
a Cover frame b Chimney c Control panel d Overhead lighting e Canopy f Grease filter g Light button This button turns the light on and off and also dims the light. The lighting can be used independently of the fan. h On/Off button i Fan power level buttons Four fan speed selection. -
Page 10: Operation
Operation Turning on the fan ^ Press the On/Off button. Selecting the power level ^ Use the "–/+" controls to select the desired power level. + = increases the fan speed – = decreases the fan speed Levels "1" to "3" (green indicators) are usually sufficient for normal cooking. - Page 11 If the power level indicators "1" and "4" flash, the automatic switch back is not activated. ^ To activate the automatic switch back press the "+" button. The power level indicators "1" and "4" light continuously. ^ To deactivate press the "–" button. ^ To save the setting press the "Delay Shut Down"...
-
Page 12: Delayed Shut Down
Operation Delayed Shut Down If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes. After that period of time the fan turns off automatically. -
Page 13: Turning The Lighting On/Off
Turning the lighting on/off The overhead lighting can be turned on and off independently of the fan. ^ Press the light button briefly to turn on the lighting. The light button indicator illuminates. ^ Press the light button briefly again to turn off the lighting. -
Page 14: Grease Filter Timer
Operation Grease filter timer A timer monitors the hours of fan operation. The indicator for the grease filter will light red after 30 hours of operation or the preselected time. The grease filter must then be cleaned. See "Cleaning and care / Grease Filter". After the grease filter has been cleaned and put back in place, the grease filter timer must be reset. - Page 15 Reprogramming the grease filter timer The grease filter timer is preset to 30 hours. This time can be lengthened or shortened to 20, 30, 40 or 50 hours. – A time of 20 hours should be programmed in kitchens with frequent pan or deep frying.
- Page 16 Operation If the grease filter timer lights blue, a different timer was activated which is not needed. Deactivating the blue indicator The fan must be off. ^ Press the "+" and the grease filter button at the same time. The grease filter indicator lights blue and one "–/+"...
-
Page 17: Cleaning And Care
Before cleaning or servicing the hood, disconnect it from the power supply by either removing the fuse, unplugging it from the outlet or manually "tripping" the circuit breaker. Cleaning the casing Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. -
Page 18: Grease Filter
Cleaning and care Grease filter The reusable metal grease filter removes solid particles from the vented kitchen air (grease, dust, etc). The grease filter and the air intake panel should be cleaned every 3 - 4 weeks or whenever the grease filter indicator lights red. - Page 19 Cleaning the grease filter ^ By hand: use a scrub brush with a solution of warm water and mild detergent. Do not use the pure detergent, aggressive all purpose cleaners, oven sprays, abrasive cleaning agents or limescale removers. They could destroy the filter. ^ In a dishwasher: place the filter vertically in the lower basket, making sure that the spray arm is not...
-
Page 20: Changing The Light Bulb
Cleaning and care Changing the light bulb Before changing the light bulbs, disconnect the hood from the power supply by either removing the fuse, unplugging it, or manually "tripping" the circuit breaker. When in use halogen bulbs become extremely hot, and can burn your hands. -
Page 21: After Sales Service
Miele’s Service department, Extended Service Contracts offered by other providers for Miele products will not be recognized by Miele. Our goal is to prevent unauthorized (and untrained) service personnel from working on your Miele products, possibly doing further damage to them, you and/or your home. -
Page 23: Installation Instructions
Installation Instructions... -
Page 25: Caring For The Environment
Disposal of packing material The cardboard box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. Please recycle. To prevent suffocation of children, ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of their reach. -
Page 26: Structural Support
Structural support The ceiling mounting plate will support the weight of the hood. This ceiling plate must be attached to rigid structural framing that is supported in its entirety by the ceiling joists, or to the ceiling joists directly. Do not attach the plate directly to the ceiling with anchors, toggle bolts, etc. -
Page 27: Electrical Data
If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or contact Miele’s Technical Service Department. See back cover for contact information. WARNING: THIS APPLIANCE MUST BE... -
Page 28: Appliance Dimensions
Appliance dimensions Exhaust connection 6" (150 mm) diameter 1) Entrance for ductwork and power cord... -
Page 29: Installation
Installation Do not install this exhaust hood over cooktops burning solid fuel. Provided a larger distance is not given by the manufacturer of the cooktop, follow the minimum safety distances between a cooktop and the bottom of the hood: - 22" (550 mm) above electric cooktops, - 30"... -
Page 30: Installation Instructions
Installation Installation instructions ^ See the enclosed installation instruction sheet. ^ Please read the "Important Safety Instructions" and Installation instructions before installing this hood. Installation accessories 4 Screws 8 x 60 mm with 4 Washers for securing the ceiling plate. (S8 wall anchors included in the packaging are not for use in USA) 2 Screws M 4 x 8 mm... -
Page 31: Air Extraction
" per foot (1 cm per meter) to prevent condensation dripping into the appliance. – If the exhaust is ducted through an outside wall, a Miele Telescopic Wall Vent can be used. -
Page 32: Condensate Trap
Air extraction – If the exhaust is ducted into an inactive flue, the air must be expelled parallel to the flow direction of the flue. Never connect an exhaust hood to an active chimney, dryer vent, flue, or room venting ductwork. Seek professional advice before connecting an exhaust hood vent to an existing, inactive chimney or vent... - Page 36 Alteration rights reserved / 0308 M.-Nr. 06 878 360 / 03 For the most updated manual see the Miele web site.