Table of Contents
Advertisement
Appendix
Care
Wipe the base station, charging cradle and
handset with a damp cloth (do not use
solvent) or an antistatic cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch off the handset and remove
the battery pack immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.
Questions and answers
If you have any questions about using
your phone, visit us at
www.gigaset.com/customercare
at any time. The table below contains a list
of common problems and possible solu-
tions.
Registration or connection problems with a
Bluetooth headset.
¥
Reset the Bluetooth headset (see the user
guide for your headset).
¥
Delete registration data from the handset
when deregistering the device
(see page 55).
¥
Repeat the registration process
(see page 55).
!
The display is blank.
1. The handset is not turned on.
¥
Press and hold the end call key
2. The battery is almost flat.
¥
Charge or replace the batteries (page 8).
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥
Press and hold the hash key
"Base station x" flashes on the display.
1. The handset is outside the range of the base
station.
¥
Move the handset closer to the base sta-
tion.
2. The base station's range is reduced because
eco mode is activated.
¥
Deactivate eco mode (page 13) or
reduce the distance between the hand-
set and the base station.
3. The handset has been deregistered.
¥
Register the handset (page 43).
4. The base station is not turned on.
¥
Check the base station's mains adapter
(page 8).
Base Search flashes in the display.
The handset is set to
Best Base
tion is turned on or within range.
¥
Move the handset closer to the base station.
¥
Check the base station's mains adapter
(page 8).
Handset does not ring.
1. The ringer melody is deactivated.
¥
Activate the ringer melody (page 50).
2. Call diversion set to
¥
Deactivate call diversion (page 19).
You cannot hear a ringer/dialling tone from
the fixed network.
The phone cord supplied has not been used or
has been replaced by a new cord with the
wrong jack connections.
¥
Please always use the phone cord supplied
or ensure that the jack connections are cor-
rect when purchasing from a retailer
(page 8).
Appendix
a
.
#
(page 11).
and no base sta-
All
Calls.
61
Hide quick links:
Advertisement
Table of Contents
