The LED will light up each time a
button is pressed on the handle.
At the end of the pause you can do one
of the following:
^ Press the Stand-by button - again to
switch the vacuum cleaner back on
at the setting you were using before
pausing it.
^ Press the + button to switch the
vacuum cleaner back on using the
highest power setting.
^ Press the - button to switch the
vacuum cleaner back on using the
lowest power setting.
Setting down, transportation
and storage
Park system for pauses in vacuuming
(dia. 28)
The Park system allows you to
conveniently park the suction tube and
floorhead during pauses.
^ Slot the floorhead into the parking
attachment at the back of the
vacuum cleaner.
If your vacuum cleaner is on a
sloping surface, e.g. a ramp, retract
the telescopic tube fully.
Switching on and off with the Park
system
Some models are fitted with an On/Off
switch in the Park system.
The vacuum cleaner switches off
automatically when the floorhead is
slotted into the Park system with the
parking attachment.
When the floorhead is removed from
the Park system the vacuum cleaner
switches back on at the last selected
power level (not on models with radio
controls on the handle).
Park system for storage (dia. 29)
,
Always disconnect the vacuum
cleaner from the electrical supply
when you have finished using it.
Switch it off at the wall socket and
unplug it.
^ Stand the vacuum cleaner upright.
Retract the telescopic tubes fully so
that the vacuum cleaner takes up
less room for storage.
^ Slot the floorhead downwards into
one of the parking attachments on
either side of the vacuum cleaner.
This makes the vacuum cleaner easier
to carry or store.
If your vacuum cleaner has an XXL
handle, you can detach this so that the
vacuum cleaner requires less storage
space (dia. 30).
^ Detach the XXL handle from the
retracted suction tube.
^ Wind the suction hose around the
suction tube and then slot the XXL
handle into the second parking
attachment.
en
41