Table of Contents
Advertisement
9
6. Click External in the Peer group type drop-down window; then click Apply.
7. Enter
8. Configure route inbound policy according to
9. Configure route redistribution policy according to
407
10. Configure an inbound route filter according to
To configuring EBGP on Nokia Platform E
1. Configure the interface as in
2. Click BGP under Configuration > Routing Configuration in the tree view.
3. Enter 300 in the AS number edit box.
4. Enter 100 in the Peer autonomous system number text box.
5. Click External in the Peer group type drop-down list; then click Apply.
6. Enter
7. Configure route inbound policy according the
page 446.
8. Configure route redistribution policy according to
407.
9. Configure an inbound route filter according to
page 446.
Verification
To verify that you configured BGP neighbors correctly, run the following command in iclid:
show bgp neighbor
For more information about this command, see to
Path Filtering Based on Communities Example
Note
To filter BGP updates based on peer AS numbers, see
Nokia Platform D based on an autonomous system number."
To filter BGP updates based on community ID or special community, specify an AS number
along with the community ID or the name of one of the following possible special community
attributes: no export, no advertise, no subconfed, or none.
1. Click the Advanced BGP options link.
2. Click on in the Enable Communities field, then click Apply.
418
in the Add remote peer IP address text box; then click Apply.
129.10.21.1
"Ethernet Interfaces."
in the Add remote peer IP address edit box; then click Apply.
172.17.10.1
"BGP Route Inbound Policy Example."
"Redistributing Routes to BGP"
"BGP Route Inbound Policy Example."
"BGP Route Inbound Policy Example"
"Redistributing Routes to BGP"
"BGP Route Inbound Policy Example"
"Viewing Routing Protocol Information."
"To configure route inbound policy on
Nokia Network Voyager for IPSO 4.0 Reference Guide
on page
on
on page
on
Advertisement
Table of Contents
Troubleshooting
