Replacing The Solid-State Drive - Lenovo ThinkCentre M79 User Manual
Hide thumbs
Also See for ThinkCentre M79:
- Hardware maintenance manual (186 pages) ,
- User manual (154 pages) ,
- Safety, warranty, and setup manual (2 pages)
Table of Contents
Advertisement
7. Connect one end of the signal cable to the rear of the new hard disk drive and the other end to an
available SATA connector on the system board. See "Locating parts on the system board" on page 6.
Then, locate an available four-wire power connector and connect it to the rear of the new hard disk drive.
Figure 23. Connecting a SATA hard disk drive
8. Position the new hard disk drive into the hard disk drive bay and align the screw holes in the new hard
disk drive with the corresponding holes in the drive bay. Then, install the four screws to secure the
new hard disk drive in place.
Figure 24. Installing the hard disk drive
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 110.
Replacing the solid-state drive
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
The solid-state drive is only available on some models. It might be installed in the hard disk drive bay or
on the bottom of the optical drive bay.
• To replace the solid-state drive in the hard disk drive bay, see "Replacing the solid-state drive in the hard
disk drive bay" on page 79.
• To replace the solid-state drive on the bottom of the optical drive bay, see "Replacing the solid-state drive
on the bottom of the optical drive bay" on page 80.
78
ThinkCentre M79 User Guide
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
