Table of Contents
Advertisement
6
Installing the CE Hood Latch
Parts needed for this procedure:
1
Hood latch assembly
1
Washer
Procedure
1. Unlatch and raise the hood.
2. Remove the rubber grommet from the hole in the left
side of the hood
(Figure
Figure 16
1. Rubber grommet
3. Remove the nut from the hood latch assembly
17).
Figure 17
1. Hood latch
2. Nut
4. Outside the hood, insert the hook end of the latch
through the hole in the hood. Make sure that the
16).
(Figure
3. Rubber washer
4. Metal washer
rubber sealing washer remains to the outer side of the
hood
(Figure
17).
5. Inside the hood, insert the metal washer onto the latch
and secure with the nut. Make sure that the latch
engages the frame catch when it is locked. Use the
enclosed hood latch key to operate the hood latch.
7
Using the Cutting Unit
Kickstand
Parts needed for this procedure:
1
Cutting unit kickstand
Procedure
Whenever the cutting unit has to be tipped to expose the
bedknife and the reel, prop up the rear of the cutting unit
with the kickstand to make sure that the nuts on the back end
of the bedbar adjusting screws are not resting on the work
surface
(Figure
18).
1. Cutting unit kickstand
Secure the kickstand to the chain bracket with the snapper
pin
(Figure
19).
18
Figure 18
Advertisement
Table of Contents
