Table of Contents
Advertisement
Servicing the Fuses
The electrical system is protected by fuses. It requires no
maintenance. If a fuse blows, check the component or
circuit for a malfunction or short. Pull out on the fuse
to remove or replace it (Figure 42).
Figure 42
1. Fuse, 25 amp, blade type
2. Fuse, 30 amp, blade type
Drive System
Maintenance
Perform the following linkage adjustments when the
machine needs maintenance. Perform steps Adjust the
Speed Control Linkage through Adjusting the Tracking.
If and adjustment is needed , do them in the order that
they are listed.
Adjusting the Speed Control
Linkage
1. Disengage the PTO and set the parking brake.
2. Stop the engine and wait for all moving parts to stop
before leaving the operating position.
3. Move the speed control lever (located on the
console) to the full forward position (Figure 43).
1. Speed control lever
2. Full speed position
3. Neutral position
4. Check the orientation of the tabs on the ends of the
speed control crank. These tabs should be pointing
straight down at the 6 o'clock position approximately
(Figure 44).
5. If adjustment is needed, loosen the nuts on both
sides of the swivel on the speed control rod
(Figure 44).
6. Adjust the swivel until the tabs are at the 6 o'clock
position (Figure 44).
7. Tighten the nuts on both sides of the swivel
(Figure 44).
35
Figure 43
4. Medium speed position
5. Control panel
Advertisement
Table of Contents
