Related Manuals for Toro 03664
Summary of Contents for Toro 03664
- Page 1 Form No. 3354–709 Rev B Verticutter Reelmaster 5210/5410 Series Cutting Unit with 5in Reel Model No. 03664—Serial No. 260000001 and Up Operator’s Manual English (EN)
-
Page 2: Table Of Contents
......Dealer or Toro Customer Service and have the model and serial numbers of your product ready. -
Page 3: Safety
• To ensure optimum performance and safety, always purchase genuine Toro replacement parts and • Always wear substantial shoes. Do not operate accessories to keep the Toro all TORO. Never use verticutters while wearing sandals, tennis shoes, “will-fit” replacement parts and accessories made by sneakers or shorts. -
Page 4: Setup
Setup Loose Parts Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be completed. Description Qty. Use when the verticutters are lowered to the shop Transport roller assembly floor Cotter pin Use to secure transport rollers... -
Page 5: Adjusting The Blade Depth
Adjusting the Blade Depth Note: The maximum recommended setting is 1/8 in. (3 mm) deep blade penetration. 1. Place the verticutter reel on a level surface. 2. Place 2 gauge bars, which have the desired depth of blade penetration below the ground, under the front and rear rollers of the verticutter reel (on each end of the reel) (Fig. -
Page 6: Adjusting The Transport Rollers
Motor Weight Weight Motor Weight Motor Motor Weight Weight Motor Figure 6 Note: Counterweights are shipped installed to the right end of the verticutters. The capscrews on the left end are to be used for securing the hydraulic motor. Verticutter reels are mounted to traction unit the same way cutting units are. -
Page 7: Operation
Operation 3. Power requirements to operate the verticutter reels will vary with turf and soil conditions. Travel speed may need to be reduced in some conditions. 4. When operating in turf conditions where much debris is Training Period encountered, or unusually heavy thatch, open the front and rear discharge shields to help allow the debris to Before operating the verticutter reels, evaluate the discharge from the reel. -
Page 8: Maintenance
Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Lubrication Each cutting unit has (7) grease fittings (Fig. 8) that must be lubricated regularly with No. 2 General Purpose Lithium Base Grease. The lubrication points are front roller (2), rear roller (2), reel bearing (2) and bedknife adjuster. -
Page 9: Removing The Verticutter Blades From The Shaft
Removing the Verticutter Install Verticutter Blades Blades from the Shaft 1. First, assemble a reel blade (Fig. 11). 1. Secure the end of the verticutter shaft, which has only 2. Next, assemble a large spacer. one washer and nut, in a vise. 3. -
Page 12: The Toro General Commercial Products Warranty
If for any reason you are dissatisfied with your Distributor’s service or have difficulty obtaining guarantee information, contact the Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company.