Configuring A T1 Channel - HP HSR6800 Configuration Manual
Interface
Hide thumbs
Also See for HSR6800:
- Configuration manual (478 pages) ,
- Command reference manual (170 pages) ,
- Installation manual (146 pages)
Table of Contents
Advertisement
Step
6.
Set the overhead bytes for E1.
7.
Configure the E1 operating
mode.
8.
Shut down the specified E1
channel.
9.
Configure the bundling mode
of the serial interface formed
by bundling the timeslots of
the E1 channel.
NOTE:
E1 configuration is supported on the CPOS (E) interface module.
Configuring a T1 channel
Step
1.
Enter system view.
2.
Enter CPOS interface view.
3.
Set the framing format for T1.
4.
Set the clock mode for T1.
5.
Set the loopback mode for T1.
Command
e1 e1-number set flag c2 c2-value
e1 e1-number set flag j2 { sdh |
sonet } j2-string
•
Method 1:
Configure E1 to operate in
unframed mode:
e1 e1-number unframed
•
Method 2:
Configure E1 to operate in
framed mode and set timeslot
bundling:
a.
(Optional) undo e1
e1-number unframed
b.
e1 e1-number channel-set
set-number timeslot-list
range
e1 e1-number shutdown
ppp mp soft-binding
undo ppp mp soft-binding
Command
system-view
controller cpos cpos-number
t1 t1-number set frame-format { esf
| sf }
t1 t1-number set clock { master |
slave }
t1 t1-number set loopback { local |
payload | remote }
61
Remarks
Optional.
By default, C2 is set to
hexadecimal 02 and J2 is cyclic
null.
Use either method.
The default setting is:
•
E1 operates in framed mode.
•
An E1 channel is not
channelized.
Optional.
Up by default.
Optional.
By default, the hardware bundling
mode is adopted.
The HIM-CL1P and HIM-CL2P
interface modules do not support
cross-port hardware MP bundling.
On these interface modules, you
can use software bundling to meet
cross-port MP requirements.
Remarks
N/A
N/A
Optional.
ESF by default.
Optional.
Slave by default.
Optional.
Disabled by default.
Advertisement
Table of Contents
Troubleshooting
