Table of Contents
Advertisement
P-30
Service Conditions (cont'd)
12. Forced release of a Paging Trunk is processed so that the station connected with that specific
Paging Trunk is regarded as having released. Therefore, after the forced release of the paging
trunk, the state of the station is as follows:
a.) if there is a call on hold: Dial Tone Connection
b.) if there is no call on hold: Recall (Calling Only)
13. Going on-hook by the station after Dial Tone connection will result in Recall. As the Paging
Memory becomes free after this Recall, a PRIORITY PAGING call can be originated.
14. Forced clearance of the Paging Memory is processed as a time-out of a paging call awaiting
answer. Therefore, after the forced Paging Memory clearance, the state of the station is as
follows:
a.) if there is no call on hold:
b.) if there is a call on hold:
Note:
If a Recall cannot be made because of a busy line, etc., the Paging Memory is not cleared until the line is
released and Recall is possible.
15. Both the COT card and the TLT card can be used as the paging trunk.
16. Loop signaling is the recommended signaling type.
Page 426
Priority Paging
(Answering - Non-Delay)
Dial Tone Connection (Answering - Delay basis)
(Paging Transfer)
Same as before clearance
Recall (Note)
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
