GMSK-modulated or 8-PSK-modulated signal to RF. Fig 1.1 Block diagram of RF part A generic, high-level functional block diagram of L704i is shown in Figure 1-1. One antenna collects base station forward link signals and radiates handset reverse link signals. The antenna connects with receive and transmit paths through a FEM(Front End Module) (plus two duplexers for UMTS high-band and low-band operations).
2. The amplitude-modulated (AM) component is applied to the ramping control pin of Polar power amplifier from a DAC within the MSM L704i power supply voltages are managed and regulated by the PM6650 Power Management IC. This versatile device integrates all wireless handset power management, general housekeeping, and user interface support functions into a single mixed signal IC.
DCS and PCS). The front end module allows multiple operating bands and modes to share the same antenna. In L704i, a common antenna connects to one of seven paths: 1) UMTS-800 Rx/Tx, 2) UMTS-2100 Rx/Tx, 3) GSM-900 Rx, 4) DCS-1800 Rx, 5) PCS-1900 Rx , 6) GSM-900 Tx, 7) DCS-1800 PCS-1900 Tx.
Important performance requirements include; ■ Insertion loss . this component is also in the receive and transmit paths ; In the L704i typical losses : UMTS2100_ Tx = 1.45 dB, UMTS2100_ Rx = 1.86 dB and UMTS800_ Tx =0.83 dB, UMTS800_ Rx = 1.23 dB...
3. TECHNICAL BRIEF L704i has a protective circuit for non-booting from USB. When the phone is booted from USB_VBUS without Battery, booting current might be insufficient. Sometimes, this scheme can break the USB port on a computer. So, L704i does not support booting from USB.
3. TECHNICAL BRIEF 3.11.5. Camera Interface L704i Installed VGA(0.3 mega Pixel) Camera and 2 Mega Pixel Auto Focus Camera. Below figure shows the camera board to board connector and camera I/F signal. CAM_VGA_PWDN VREG_VGA_CAM_2.8V HB-1M1005-600JT CAM_MCLK VREG_CAM_2.7V CAM_VGA_RESET CAM_PCLK CAM_I2C_SCL...
4. TROUBLE SHOOTING 4.8. USB Troubleshooting USB Initial sequence of L704i is : USB connected to L704i power on → USB_VBUS(Q7 PIN4) go to 5V → USB_D+ go to 3.3V → USB_VP and USB_VN is triggered → USB work. Start...
LGMDP supports Windows 2000/XP where the LG USB modem driver is installed. Additionally, LGMDP allows multi downloading up to 8 handsets at the same time.