Saving A Configuration; Clearing A Configuration; Using Switch File Systems - Cisco nexus 5000 series Cli Configuration Manual
Hide thumbs
Also See for nexus 5000 series:
- Configuration manual (334 pages) ,
- Command reference manual (196 pages) ,
- Operation manual (45 pages)
Table of Contents
Advertisement
Using Switch File Systems
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
version of the current startup configuration that was used to boot the switch if a copy running-config
startup-config command was not entered after the reboot. Use the show startup-config command to
view the contents of the current startup configuration.
You can also gather specific information on the entire switch configuration by entering the relevant show
commands. Configurations are displayed based on a specified feature, interface, module, or VSAN.
Available show commands for each feature are briefly described in this section and listed at the end of
each chapter.
Saving a Configuration
Use the copy running-config startup-config command to save the new configuration into nonvolatile
storage. Once this command is entered, the running and the startup copies of the configuration are
identical.
Clearing a Configuration
Use the write erase command to clear a startup configuration. Once this command is executed, the
switch's startup configuration reverts to factory defaults. The running configuration is not affected.
The write erase command erases the entire startup configuration with the exception of any
Caution
configuration that affects the loader functionality.
The write erase boot command only erases the configuration that affects the loader functionality. The
loader functionality configuration includes the boot variables and the mgmt0 IP configuration
information (IP address, netmask, and default gateway).
switch# write erase boot
This command will erase the boot variables and the IP configuration of interface mgmt 0.
Using Switch File Systems
This section includes the following topics:
•
•
•
•
•
•
•
•
•
•
•
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
1-22
Setting the Current Directory, page 1-23
Displaying the Current Directory, page 1-23
Listing the Files in a Directory, page 1-23
Creating a Directory, page 1-23
Deleting an Existing Directory, page 1-24
Moving Files, page 1-24
Copying Files, page 1-24
Deleting Files, page 1-25
Displaying File Contents, page 1-25
Saving Command Output to a File, page 1-25
Compressing and Uncompressing Files, page 1-25
Chapter 1
Configuring the Switch
OL-16597-01
Advertisement
Chapters
Table of Contents
Troubleshooting
