Creating Zone Sets And Adding Member Zones; Zone Enforcement - Cisco nexus 5000 series Cli Configuration Manual
Hide thumbs
Also See for nexus 5000 series:
- Configuration manual (334 pages) ,
- Command reference manual (196 pages) ,
- Operation manual (45 pages)
Table of Contents
Advertisement
Zone Sets
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Creating Zone Sets and Adding Member Zones
To create a zone set to include several zones, perform this task:
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# zoneset name zoneset-name
vsan vsan-id
switch(config-zoneset)#
Step 3
switch(config-zoneset)# member name
Step 4
switch(config-zoneset)# zone name zone-name
switch(config-zoneset-zone)#
Step 5
switch(config-zoneset-zone)# member fcid
fcid
switch(config-zoneset-zone)#
You do not have to copy the running configuration to the startup configuration to store the active zone
Tip
set. However, you need to copy the running configuration to the startup configuration to explicitly store
full zone sets.
Be sure you understand how device alias modes work before enabling them. See
Note
Device Alias Services"
Zone Enforcement
Zoning can be enforced in two ways: soft and hard. Each end device (N port) discovers other devices in
the fabric by querying the name server. When a device logs in to the name server, the name server returns
the list of other devices that can be accessed by the querying device. If an N port does not know about
the FC IDs of other devices outside its zone, it cannot access those devices.
In soft zoning, zoning restrictions are applied only during interaction between the name server and the
end device. If an end device somehow knows the FC ID of a device outside its zone, it can access that
device.
Hard zoning is enforced by the hardware on each frame sent by an N port. As frames enter the switch,
source-destination IDs are compared with permitted combinations to allow the frame at wire speed. Hard
zoning is applied to all forms of zoning.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
1-12
for details and requirements about device alias modes.
Chapter 1
Configuring and Managing Zones
Purpose
Enters configuration mode.
Configures a zone set called Zoneset1.
To activate a zone set, you must first
Tip
create the zone and a zone set.
Adds Zone1 as a member of the specified zone set
(Zoneset1).
If the specified zone name was not
Tip
previously configured, this command will
return a "zone not present" error
message:
Adds a zone to the specified zone set.
Tip
Execute this step only if you need to
create a zone from a zone set prompt.
Adds a new member to the new zone.
Execute this step only if you need to add
Tip
a member to a zone from a zone set
prompt.
Chapter 1, "Distributing
OL-16597-01
Advertisement
Chapters
Table of Contents
Troubleshooting
