Table of Contents
Advertisement
11. OPERATION OF YOUR OPERATOR
Your operator can be activated via any of the following, depending on which
accessories your opener system has:
• Remote Control Transmitter
• Wall Control Panel
• Keyless Entry (optional accessory)
REMOTE CONTROL TRANSMITTER:
• To open or close garage door, press and hold button (Transmitter has an
indicator light that will illuminate) (see Fig. 47A). When garage door
begins to move, release button.
• To stop garage door during travel, press and hold button until door stops,
then release button.
• To resume garage door travel after stopping, press button again. Door
begins to move in the opposite direction.
WALL CONTROL PANEL:
• The Door Pushbutton will light when Wall Control properly connected (if
it does not light up, review section 8-11. "Install Wall Control" on page 15
or refer to "Having a Problem" on page 33). To open or close garage door,
press and hold Illuminated Door Pushbutton (see Fig. 48). When garage
door begins to move, release button.
To stop garage door during travel, press and hold button until
door stops, then release button.
To resume garage door travel after stopping it, press button
again. Door begins to move in the opposite direction.
NOTE: For multi-button transmitters, be sure to carry out this procedure for
all the buttons you desire to use.
• The Light On / Off button can be used to turn lights on or off. When using
the light On / Off button, the automatic timer is ignored, and the lights will
remain on until the button is pressed again, or until the operator is
activated and the automatic timer begins again.
• The Lock/Vacation button can be used to lock out all remote control
transmitters. The door can still be activated by wall control panel or
keyless entry system. Press and hold Lock/Vacation button for 2-3
seconds. Release button. Illuminated Door Pushbutton will flash
continuously while lock mode is active. To unlock opener, press and hold
Lock/Vacation button for 2-3 seconds.
OPERATOR LIGHTS:
• The amount of time that the operator light(s) are "on" can be adjusted.
Please refer to level 5 menu 4 in the "Advanced Settings"
• Lights will come on whenever operator is activated. The default factory
setting for the light to stay "on" is 4 minutes and 15 sec., or until the Light
On / Off button on the wall control panel is pressed, whichever is sooner.
• Lights can be turned on and off manually as described under operation
of wall control panel.
• Lights will flash when the operator senses an obstruction either detected
by the internal safety system or the photo eye sensors. To stop lights
from flashing, remove obstruction and operate door normally. The fault
light indicator will flash for the set light time "on" factory default setting of
3 minutes maximum.
Fig. 41
A. Transmitter
Indicator Light
Buttons
B. Wall Control Panel
Lock/Vacation Button
Light On/Off Button
Illuminated Door Pushbutton
Important Note: If the vacation
lock mode is engaged.
By pressing and holding the light button or the
door activation button for one second or longer
will disengaged the vacation lock mode.
Fig. 42
Fig. 43
12. HOMELINK® TRANSCEIVER
Before you can use your car's HomeLink® device to open a garage
door you must transfer an active code from the transmitter to the
HomeLink® Universal transceiver. (Reference - HomeLink®
Manual, see Fig. 42).
13. MODULAR ANTENNA
To replace modular antenna simply pull out existing module located
on the top of the chassis, and slide in the new one. It will make a
clicking sound when the receiver module is locked into place (see
Fig. 43).
27
Hide quick links:
Advertisement
Table of Contents
