Table of Contents
Advertisement
Card Reader-F1
Checking the Contents
<Card Reader-F1>
[1]
[1]Card readerx1
[2]Screw (RS Tightening; M4x10) x1 *1
[3]Toothed washerx1*1
*1 Not used in this host machine.
<Card reader attachment-D3>
[2]
[1]
[4]
[1]Card reader mountx1
[2]Card reader cover x1
[3]Harness cover (base + lid) )x3*4
[4]Relay harness Bx1
[5]Edge saddlex1
[6]Screw(TP ; M4X16) x2*3
[7]Screw( Binding ; M4X6) x4
[8]Cord retainerx1*1
[9]Reuse bandx1*1
[10]Relay harness Cx1
[11]Wire Saddlex1
[12]Screw(TP ; M4X6) x2*2
*1 Not used in this host machine.
[2]
[3]
[3]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]
*2 Use only for iR2545/2535.
*3 Use for iR2530/2525/2520 or use for the installation of the
Card Reader-F1 and the USB.
*4 The 2 Harness covers are not used in this host machine.
Checking before Installation
■ Check Items when turning OFF the
Main Power
Check that the main power switch is OFF.
1. Turn OFF the main power switch of the host machine.
2. Be sure that control panel display and main power lamp
are both turned OFF, and then disconnect the power
plug.
Installation Procedure
■ a. When Installing the card reader in
a simple substance
1. Remove the rear cover (right).
• 3 Screws
• 2 Claws
3x
324
9. Installation
Advertisement
Table of Contents
Troubleshooting
