Table of Contents
Advertisement
Administration: File Management
Upgrade/Backup Firmware/Language
STEP 1
STEP 2
STEP 3
Cisco Small Business 200 Series Smart Switch Administration Guide
Upgrade/Backing Firmware or Language File
To upgrade or backup a software image or language file:
Click Administration > File Management > Upgrade/Backup Firmware/
Language.
Click the Transfer Method. Proceed as follows:
•
If you selected TFTP, go to
•
If you selected via HTTP/HTTPS, go to
•
If you selected via SCP, go to
If you selected via TFTP, enter the parameters as described in this step.
Otherwise, skip to
STEP
Select one of the following Save Actions:
•
Upgrade—Specifies that the file type on the device is to be replaced with a
new version of that file type located on a TFTP server.
•
Backup—Specifies that a copy of the file type is to be saved to a file on
another device.
Enter the following fields:
•
File Type—Select the destination file type. Only valid file types are shown.
(The file types are described in the
•
TFTP Server Definition—Select whether to specify the TFTP server by IP
address or domain name.
•
IP Version—Select whether an IPv4 or an IPv6 address is used.
•
IPv6 Address Type—Select the IPv6 address type (if IPv6 is used). The
options are:
-
Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
-
Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
STEP
3.
STEP
5.
4.
Files and File Types
STEP
4.
section).
4
36
Advertisement
Table of Contents
