Gnss Module Rf Input Requirements - Cisco ASR 902 Hardware Installation Manual
Hide thumbs
Also See for ASR 902:
- Hardware installation manual (160 pages) ,
- Installation manual (48 pages) ,
- Troubleshooting manual (18 pages)
Table of Contents
Advertisement
Overview
The GNSS module is not hot swappable.
Note
GNSS Module RF Input Requirements
• The GNSS module requires an active GPS/GNSS antenna with built-in Low-Noise Amplifier (LNA)
for optimal performance. The antenna LNA amplifies the received satellite signals for two purposes:
The Amplification required is 22dB gain + cable/connector loss + Splitter signal loss.
The recommended range of LNA gain (LNA gain minus all cable and connector losses) at the connector
of the receiver module is 22dB to 30dB with a minimum of 20dB and a maximum of 35dB.
• GNSS module provides 5V to the active antenna through the same RF input.
• Surge requirement:
• Antenna Sky visibility:
• Use a passive splitter if more than one GNSS modules are fed from a single antenna.
The splitter should have all the RF ports capable of DC-pass, if the antenna needs to feed power from
Note
GNSS module.
For information on pinout, see
◦ Compensation of losses on the cable
◦ Lifting the signal amplitude in the suitable range for the receiver frontend
• GNSS modules have built-in ESD protections on all pins, including the RF-input pin. However,
additional surge protection may be required if rooftop antennas are being connected, to meet the
regulations and standards for lightning protection in the countries where the end-product is installed.
• A lightning protection must be mounted at the place where the antenna cable enters the building.
The primary lightning protection must be capable of conducting all potentially dangerous electrical
energy to PE (Protective Earth).
• Surge arrestors should support DC-pass and suitable for the GPS frequency range (1.575GHz)
with low attenuation.
◦ GPS signals can only be received on a direct line of sight between antenna and satellite. The antenna
should see as much as possible from the total sky. For proper timing, minimum of four satellites
should be locked.
The antenna terminal should be earthed at the building entrance in accordance with the
Note
ANSI/NFPA 70, the National Electrical Code (NEC), in particular Section 820.93,
Grounding of Outer Conductive Shield of a Coaxial Cable.
GPS Port Pinouts
Cisco ASR 902 and ASR 902U Aggregation Services Router Hardware Installation Guide
GNSS Module (A900-CM-GNSS)
.
21
Advertisement
Table of Contents
