Checking Initialization; Connecting The Scanner To Your Computer; Connecting The Scanner Using The Scsi Interface - Epson 1680 Manual

Color image, expression series

Hide thumbs Also See for 1680:

Table of Contents

Checking initialization

Before connecting the scanner to your computer, follow the steps below to make sure

that the scanner initializes, or starts up, properly.

1. Open the document cover so you can see the operation of the scanner during

initialization.

2. Turn on the scanner by pressing the

3. Make sure the fluorescent lamp on the carriage and the READY light flash, and the

carriage moves slightly.

4. When the READY light stops flashing and stays on, it means the scanner has

completed initialization.

5. Turn off the scanner.

If the scanner does not work as described, make sure the power cord is firmly plugged

in and that you have released the transportation lock, then try again.

Caution:

Whenever you turn off the scanner, wait at least 10 seconds before turning

it back on. Rapidly turning the scanner on and off can damage it.

For instructions on connecting the scanner to your computer using the SCSI interface,

read this section.

Note for Macintosh® users:

You need to install the scanner software before connecting the scanner to your

computer. Follow the instructions in Chapter 3 of the online Setup Guide to install your

software, then connect your scanner as described here.

operate button.

Table of Contents

1680 pro