• It is imperative to keep the piping system free of contaminants and debris such as copper burrs, slag, or carbon dust during installation. 1. All joints are brazed in the field. Multi V IV refrigeration system components contain very small capillary tubes, small orifices, electronic expansion valves, oil separators, and heat exchangers that can easily become blocked.
• Do not over-tighten flare nuts. Excessive tightening will cause fittings to crack. • Multi V refrigeration system components contain very small capillary tubes, small orifices, electronic expansion valves, oil separators, and heat exchangers that can easily become blocked. Insulating the Piping Figure 8: Refrigerant Piping Connection Insulation Detail.
U.S. National Electric Code (NEC), and who is equipped with the proper tools and test instruments. Failure to carefully read and follow all instructions in this manual can result in equipment malfunction or property damage and will void the LG limited liability warranty.
The minimum distance required between power wires and the communications cable is voltage/amperage dependent and in cases where either are relatively high the minimum distance may be more than two (2) inches. Refer to the appropriate LG Multi V Outdoor Unit Engineering Manual on www.lg-vrf.com for detailed information.
Models 0A****, 1A, 2A *Gen 4 Air / Water Source Units = Multi V IV or Multi V Water IV with Gen 4 software (see table below for Gen 4 serial numbers) or Multi V S. Gen 2 Air / Water Source Units = Multi V II, Multi V III, Multi V IV without Gen. 4 software, Multi V Water II, Multi V Water IV without Gen. 4 software, Multi V Mini, Multi V Water Mini, or Multi V Space II.
Page 32
**To enable Generation 4 features, outdoor unit DIP Switch No. 3 must be set to ON. Please refer to the Multi V IV, Multi V Wa- ter IV, Multi V S Engineering Manual for additional information.
(55) inches above the finished floor. • It may be necessary to use a handy box that is sized in metric units, depending on the controller model. Check with your LG representative to verify which size of handy box is needed for the zone controller in question.
**To enable Generation 4 features, outdoor unit DIP Switch No. 3 must be set to ON. Please refer to the Multi V IV, Multi V Wa- ter IV, Multi V S Engineering Manual for additional information.
Page 40
Who to call for assistance Freight Damage and Unit Replacements Your LG Manufacturer Representative Missing Parts Your LG Manufacturer Representative Freight Damage and Unit Replacements Your LG Manufacturer Representative Received Wrong Indoor Unit Model Your LG Manufacturer Representative Installation, Startup, and Commissioning Technical Assistance 1-888-865-3026 For warranty information, visit www.lghvac.com.
Page 41
20001747 ISO 9001: 2008 LG ELECTRONICS INC. LG Electronics, U.S.A., Inc. LG Electronics Products Support Commercial Air Conditioning Division 1-888-865-3026 USA 4300 North Point Parkway Follow the prompts for HVAC products. Alpharetta, Georgia 30022 IM_MultiV_IV_Floor_Standing_8_17 Supersedes: IM_MultiV_IV_Floor_Standing_7_16 www.lg-vrf.com...