Routing Information Protocol (Rip); Protocol Overview; Ripv1; Ripv2 - Dell S4048–ON Configuration Manual
S-series 10gbe switches
Hide thumbs
Also See for S4048–ON:
- Configuration manual (1146 pages) ,
- Installation manual (42 pages) ,
- Getting started manual (42 pages)
Table of Contents
Advertisement
44
Routing Information Protocol (RIP)
The Routing Information Protocol (RIP) tracks distances or hop counts to nearby routers when establishing network connections
and is based on a distance-vector algorithm.
RIP is based on a distance-vector algorithm; it tracks distances or hop counts to nearby routers when establishing network
connections.
RIP protocol standards are listed in the
Standards Compliance
chapter.
Protocol Overview
RIP is the oldest interior gateway protocol.
There are two versions of RIP: RIP version 1 (RIPv1) and RIP version 2 (RIPv2). These versions are documented in RFCs 1058 and
2453.
RIPv1
RIPv1 learns where nodes in a network are located by automatically constructing a routing data table.
The routing table is established after RIP sends out one or more broadcast signals to all adjacent nodes in a network. Hop counts of
these signals are tracked and entered into the routing table, which defines where nodes in the network are located.
The information that is used to update the routing table is sent as either a request or response message. In RIPv1, automatic updates
to the routing table are performed as either one-time requests or periodic responses (every 30 seconds). RIP transports its
responses or requests by means of user datagram protocol (UDP) over port 520.
RIP must receive regular routing updates to maintain a correct routing table. Response messages containing a router's full routing
table are transmitted every 30 seconds. If a router does not send an update within a certain amount of time, the hop count to that
route is changed to unreachable (a route hop metric of 16 hops). Another timer sets the amount of time before the unreachable
routes are removed from the routing table.
This first RIP version does not support variable length subnet mask (VLSM) or classless inter-domain routing (CIDR) and is not
widely used.
RIPv2
RIPv2 adds support for subnet fields in the RIP routing updates, thus qualifying it as a classless routing protocol.
The RIPv2 message format includes entries for route tags, subnet masks, and next hop addresses. Another enhancement included in
RIPv2 is multicasting for route updates on IP multicast address 224.0.0.9.
Implementation Information
Dell Networking OS supports both versions of RIP and allows you to configure one version globally and the other version on
interfaces or both versions on the interfaces.
The following table lists the defaults for RIP in Dell Networking OS.
710
Routing Information Protocol (RIP)
Advertisement
Table of Contents
Troubleshooting
