Dell S4048–ON Configuration Manual page 349

S-series 10gbe switches

Hide thumbs Also See for S4048–ON:

Table of Contents

The host's third message indicates that it is only interested in traffic from sources 10.11.1.1 and 10.11.1.2. Because this request

again prevents all other sources from reaching the subnet, the router sends another group-and-source query so that it can

satisfy all other hosts. There are no other interested hosts so the request is recorded.

Figure 50. Membership Reports: Joining and Filtering

Leaving and Staying in Groups

The following illustration shows how multicast routers track and refresh state changes in response to group-and-specific and general

Host 1 sends a message indicating it is leaving group 224.1.1.1 and that the included filter for 10.11.1.1 and 10.11.1.2 are no longer

The querier, before making any state changes, sends a group-and-source query to see if any other host is interested in these

two sources; queries for state-changes are retransmitted multiple times. If any are, they respond with their current state

information and the querier refreshes the relevant state information.

Separately in the following illustration, the querier sends a general query to 224.0.0.1.

Host 2 responds to the periodic general query so the querier refreshes the state information for that group.

Internet Group Management Protocol (IGMP)

Troubleshooting