Siemens SINUMERIK 840D sl Configuration Manual page 169
Sinumerik step 7 toolbox
v14 sp1
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
NCU properties
The Safety Integrated mode of the NCU affects not only the configuration of the integrated
PLC, but rather also that of the integrated drives.
SINAMICS Integrated and NX modules always use automatically the same Safety Integrated
mode as the associated NCU.
Therefore, set this mode in the NCU properties and not in the PLC properties:
Figure 9-5
With the activation of a Safety Integrated mode, the F-capability of the PLC is set appropriate
for the Safety Integrated mode of the NCU.
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017, A5E41846325
Changing the Safety Integrated mode
Safety configuration
9.4 Parameterization of relevant properties
169
- Quick Links:
- Installation Notes
- Sinumerik Ncu
Hide quick links:
Advertisement
Table of Contents
